...
首页> 外文期刊>Diffusion and Defect Data. Solid State Data, Part A. Defect and Diffusion Forum >Oxidation Behavior of TiAl3 Formed in Ti/AI Diffusion Couple and Reaction Diffusion in Ti/TiAl3 Multi-phase Diffusion Couple
【24h】

Oxidation Behavior of TiAl3 Formed in Ti/AI Diffusion Couple and Reaction Diffusion in Ti/TiAl3 Multi-phase Diffusion Couple

机译:Ti / Al扩散相中形成的TiAl3的氧化行为和Ti / TiAl3多相扩散对中的反应扩散

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Oxidation resistance of TiAl3, one of the candidates of coating materials for high temperature structural materials such as T13AI and TiAl, has been studied. Specimens were prepared by forming TiAl3 in Al/Ti/Al reaction diffusion couples at 923 K and then TiAl3 layer was exposed to air by dissolving Al plate in a IN NaOH solution. The obtained TiAl3/Ti/TiAl3 couples were annealed in air in the temperature range from 1173 K to 1468 K. The oxidation rate was compared with that determined by using bulk TiAl3. The present data show a bend on the Arrlienius plot of parabolic phase growth rate constant, k2, at 1323 K. Above 1323K, the constant coincides well with the extrapolated values of bulk data while the value in the lower temperature range is larger than that of bulk specimens. During the oxidation experiments, intermetallic compounds Ti3Al, TiAl and TiAl3 were formed between Ti and TiAl3. Interdiffusion coefficients in the Ti3Al, TiAl phases determined from these diffusion couples are more than one order of magnitude larger than the interdiffusion coefficients determined by previous investigators from single-phase diffusion couples but coincide with the coefficients determined from multi-phase diffusion couples. This difference between interdiffusion coefficients has been discussed and explained by the effect of boundary diffusion in the diffusion layers formed in the multi-phase diffusion couples.
机译:已经研究了TiAl3的抗氧化性,TiAl3是高温结构材料的涂层材料如T13Al和TiAl的候选材料之一。通过在923 K下在Al / Ti / Al反应扩散对中形成TiAl3来制备样品,然后通过将Al板溶于1N NaOH溶液使TiAl3层暴露于空气。将所获得的TiAl3 / Ti / TiAl3对在空气中于1173 K至1468 K的温度下进行退火。将氧化速率与使用块状TiAl3测定的氧化速率进行比较。当前数据显示了在1323 K时抛物线相生长速率常数k2在Arrlienius曲线上的弯曲。在1323K之上,该常数与体数据的外推值很好地吻合,而在较低温度范围内的值大于外推数据的外推值。大块标本。在氧化实验期间,在Ti和TiAl3之间形成金属间化合物Ti3Al,TiAl和TiAl3。由这些扩散偶确定的Ti3Al,TiAl相中的互扩散系数比以前的研究人员从单相扩散偶确定的互扩散系数大一个数量级,但与多相扩散偶确定的系数一致。已经通过在多相扩散对中形成的扩散层中的边界扩散的影响来讨论和解释了互扩散系数之间的差异。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号