首页> 外文期刊>Journal of Endodontics: Official Journal of American Association of Endodontists >An evaluation of setting time of mineral trioxide aggregate and endosequence root repair material in the presence of human blood and minimal essential media
【24h】

An evaluation of setting time of mineral trioxide aggregate and endosequence root repair material in the presence of human blood and minimal essential media

机译:在存在人类血液和最少必需培养基的情况下评估三氧化二矿骨料和内序列根修复材料的凝固时间

获取原文
获取原文并翻译 | 示例
       

摘要

Introduction: The purpose of this study was to compare the ability of MTA (Dentsply Maillefer, Tulsa, OK) and EndoSequence Root Repair Material (ESRRM; Brasseler USA, Savannah, GA) to set in the presence of human blood and minimal essential media. Methods: A model was created using polymethyl methacrylate blocks each prepared with 10 standardized wells (2-mm diameter × 3-mm depth). Prepared ProRoot MTA (Dentsply Maillefer) and ESRRM were each placed in 6 separate blocks. The samples were distributed among the 4 different media (ie, blood, minimal essential media, blood and minimal essential media, and sterile saline as the control). Each block was submerged for 4, 5, 6, 8, 24, 36, and 48 hours in an incubator at 37 C with 100% humidity. Results: The results revealed that regardless of the type of media exposure, neither of the materials set at 4 or 6 hours. ESRRM was not set at 48 hours, whereas all of the MTA samples were set at 36 hours. Conclusions: This outcome draws into question the proposed setting time given by each respective manufacturer. Furthermore, despite ESRRM being marketed as a direct competitor to MTA with superior handling properties, MTA consistently set at a faster rate under the conditions of this study.
机译:简介:本研究的目的是比较MTA(Dentsply Maillefer,Tulsa,OK)和EndoSequence根修复材料(ESRRM; Brasseler USA,Savannah,GA)在人血和最低限度必需培养基存在下凝固的能力。方法:使用聚甲基丙烯酸甲酯嵌段建立模型,每个嵌段均配有10个标准化孔(直径2毫米×深度3毫米)。准备好的ProRoot MTA(Dentsply Maillefer)和ESRRM分别放置在6个单独的块中。将样品分布在4种不同的培养基中(即血液,基本必需培养基,血液和基本必需培养基以及无菌生理盐水作为对照)。将每个模块在37°C,100%湿度的培养箱中浸没4、5、6、8、24、36和48小时。结果:结果表明,不管介质暴露的类型如何,这两种材料均未设置为4或6小时。 ESRRM未设置为48小时,而所有MTA样本均设置为36小时。结论:这个结果使每个制造商给出的建议凝固时间受到质疑。此外,尽管ESRRM是具有卓越处理性能的MTA的直接竞争对手,但在本研究条件下MTA始终以更快的速度设定。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号