...
首页> 外文期刊>Journal of Chemical Technology & Biotechnology >Removal of styrene from dilute gaseous waste streams using a trickle-bed bioreactor: Kinetics, mass transfer and modeling of biodegradation process
【24h】

Removal of styrene from dilute gaseous waste streams using a trickle-bed bioreactor: Kinetics, mass transfer and modeling of biodegradation process

机译:使用滴流床生物反应器从稀薄的气态废物流中去除苯乙烯:动力学,传质和生物降解过程建模

获取原文
获取原文并翻译 | 示例
           

摘要

The removal of styrene from air streams in a co-current gas-liquid downflow trickle-bed bioreactor (TBB) inoculated with Pseudomonas sp. E-93486 strain was studied experimentally. The experiments were conducted to determine such parameters of the bioprocess as gas and liquid flow rates and specific styrene loading for which maximum elimination capacity was achieved. RESULT: The effect of inlet styrene concentration in gas phase on its degradation was studied in the range from 0.08 to 1.1 g m ~(-3). The recirculation rate of the liquid medium was changed from 0.17 to 0.35 m ~3 h ~(-1) whereas the gas flow rate was changed in the range from 1.2 to 6 m ~3 h ~(-1). The treatment of air streams contaminated with styrene in a trickle-bed bioreactor was described with a mathematical model. The model incorporates mass transfer in both the gas and liquid phases and a biological reaction in biofilm. The rate of the partial stages of the process was determined experimentally. Microbial growth tests in the presence of styrene as the sole carbon and energy source were performed both in batch and continuous cultures. The Haldane model was used to describe Pseudomonas sp. E-93486 strain growth kinetics on styrene. CONCLUSION: The experiments conducted showed high activity of the examined bacterial strain in the styrene biodegradation process and relatively low sensitivity to inhibition of its growth at higher concentrations of styrene in the solution. The results of the experiments carried out in TBB were compared with the values obtained from a mathematical model. Satisfactory compatibility of the calculated and experimental data was obtained.
机译:在用假单胞菌sp。接种的并流气液向下滴流床生物反应器(TBB)中从气流中去除苯乙烯。对E-93486菌株进行了实验研究。进行实验以确定生物过程的参数,例如气体和液体的流速以及达到最大消除能力的特定苯乙烯负载量。结果:研究了气相中进口苯乙烯浓度对其降解的影响,范围为0.08至1.1 g m〜(-3)。液体介质的再循环速度从0.17变为0.35 m〜3 h〜(-1),而气体流速在1.2到6 m〜3 h〜(-1)范围内变化。用数学模型描述了在滴流床生物反应器中处理被苯乙烯污染的气流的方法。该模型将气相和液相中的质量传递与生物膜中的生物反应结合在一起。该过程的部分阶段的速率是通过实验确定的。在分批培养和连续培养中均以苯乙烯为唯一碳源和能源进行了微生物生长测试。 Haldane模型用于描述假单胞菌。 E-93486菌株在苯乙烯上的生长动力学。结论:所进行的实验表明,所检测的细菌菌株在苯乙烯生物降解过程中具有较高的活性,并且在溶液中较高浓度的苯乙烯中对其抑制其生长的敏感性相对较低。将在TBB中进行的实验结果与从数学模型获得的值进行比较。计算和实验数据的兼容性令人满意。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号