...
【24h】

Deposition and characterization of magnetron sputtered amorphous Cr-C films

机译:磁控溅射非晶态Cr-C膜的沉积与表征

获取原文
获取原文并翻译 | 示例
           

摘要

Thin films in the Cr-C system with carbon content of 25-85 at.% have been deposited using non-reactive DC magnetron sputtering from elemental targets. Analyses with X-ray diffraction and transmission electron microscopy confirm that the films are completely amorphous. Also, annealing experiment show that the films had not crystallized at 500 °C. Furthermore, X-ray spectroscopy and Raman spectroscopy show that the films consist of two phases, an amorphous CrC _x phase and an amorphous carbon (a-C) phase. The presence of two amorphous phases is also supported by the electrochemical analysis, which shows that oxidation of both chromium and carbon contributes to the total current in the passive region. The relative amounts of these amorphous phases influence the film properties. Typically, lower carbon content with less a-C phase leads to harder films with higher Young's modulus and lower resistivity. The results also show that both films have lower currents in the passive region compared to the uncoated 316L steel substrate. Finally, our results were compared with literature data from both reactively and non-reactively sputtered chromium carbide films. The comparison reveals that non-reactive sputtering tend to favour the formation of amorphous films and also influence e.g. the sp ~2/sp ~3 ratio of the a-C phase.
机译:Cr-C系统中的碳含量为25-85 at。%的薄膜已使用非反应性直流磁控溅射从元素靶上沉积。通过X射线衍射和透射电子显微镜进行分析,确认该膜是完全非晶态的。另外,退火实验表明该膜在500℃下没有结晶。此外,X射线光谱法和拉曼光谱法显示膜由两相组成,非晶相C 1 -C相和非晶碳(a-C)相。电化学分析还支持了两种非晶相的存在,这表明铬和碳的氧化都有助于无源区中的总电流。这些非晶相的相对量影响膜的性质。通常,较低的碳含量和较少的a-C相会导致具有较高的杨氏模量和较低的电阻率的较硬膜。结果还表明,与未镀膜的316L钢基材相比,两种膜在无源区域中的电流均较低。最后,将我们的结果与反应性和非反应性溅射碳化铬薄膜的文献数据进行了比较。比较表明,非反应性溅射趋向于有利于非晶膜的形成,并且还影响例如非晶硅。 a-C相的sp〜2 / sp〜3比。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号