...
首页> 外文期刊>Hydrometallurgy >Hydrometallurgical processing of a Nigerian sphalerite in hydrochloric acid: Characterization and dissolution kinetics
【24h】

Hydrometallurgical processing of a Nigerian sphalerite in hydrochloric acid: Characterization and dissolution kinetics

机译:尼日利亚闪锌矿在盐酸中的湿法冶金工艺:表征和溶解动力学

获取原文
获取原文并翻译 | 示例
           

摘要

This study is concerned with the physio-chemical characterization and investigation of the dissolution kinetics of a Nigerian sphalerite in hydrochloric acid (HC1). The effects of HCI concentration, temperature, particle diameter, stirring speed, solid/liquid ratio on the leaching of sphalerite were investigated. The XRF analysis showed that the sphalerite mineral consists of zinc and sulphur as major elements with Fe, Sn, Ag, K, Sb, Ca and Pb occurring as minor or trace elements. The XRD examination confirmed the originality of the sphalerite sample and it revealed the presence of associated minerals such as ilmenite (FeTiO_3), pyrite (FeS_2), siderite (FeCO_3), a-quartz and cassiterite (SnO_2). Optical microscopic examination also supported the above. The leaching experiments showed that sphalerite dissolution in HCI increases with acid concentration and temperature, but decreases with particle diameter and solid/liquid ratio. In HCI 4 M and at 80 °C, about 91.80% of sphalerite was dissolved within 120 min using —112 + 63 um particle diameter and solid/liquid ratio of l0 g/L. The activation energy calculated from the experimental data was 39.09 kJ/mol, while the reaction order, Arrhenius constant and reaction constant of 0.24, 13.46s~(-1) and 2.21 +- 0.4 × l0~3 were computed for the process respectively. Kinetic data analysis indicated that the rate determining step for the dissolution process followed a surface chemical reaction and the reaction data fitted shrinking core model for spherical particles. Finally, the XRD analysis of the post-leaching residue provided evidence for the presence of silica and traces of sulphur in the residual solid.
机译:这项研究涉及尼日利亚闪锌矿在盐酸(HC1)中的理化特性和溶解动力学研究。研究了盐酸浓度,温度,粒径,搅拌速度,固液比对闪锌矿浸出的影响。 XRF分析表明,闪锌矿矿物以锌和硫为主要元素,以Fe,Sn,Ag,K,Sb,Ca和Pb为次要元素或痕量元素。 XRD检查证实了闪锌矿样品的原始性,并揭示了伴生矿物的存在,例如钛铁矿(FeTiO_3),黄铁矿(FeS_2),菱铁矿(FeCO_3),α-石英和锡石(SnO_2)。光学显微镜检查也支持上述观点。浸出实验表明,闪锌矿在盐酸中的溶解度随酸浓度和温度的升高而增加,但随粒径和固液比的降低而降低。在-112 + 63 um粒径和10 g / L的固/液比下,在HCl 4 M中和80°C下,约91.80%的闪锌矿在120分钟内溶解。由实验数据计算得到的活化能为39.09 kJ / mol,计算出该反应的反应级数,阿累尼乌斯常数和反应常数分别为0.24、13.46s〜(-1)和2.21±0.4×10〜3。动力学数据分析表明,溶解过程的速率确定步骤遵循表面化学反应,反应数据符合球形颗粒的收缩核模型。最后,对浸出后残留物的XRD分析提供了残留固体中存在二氧化硅和痕量硫的证据。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号