首页> 外文期刊>Water Science and Technology >Three stages MBR (methanogenic, aerobic biofilm and membrane filtration) for the treatment of low-strength wastewaters
【24h】

Three stages MBR (methanogenic, aerobic biofilm and membrane filtration) for the treatment of low-strength wastewaters

机译:三阶段MBR(甲烷生成,好氧生物膜和膜过滤)用于处理低强度废水

获取原文
获取原文并翻译 | 示例
           

摘要

The use of a new three stages MBR process with a first methanogenic UASB stage, a second stage with aerobic biofilm growing on small carrier elements maintained in suspension and third stage with membrane filtration module is presented. The objective of the first methanogenic chamber is to diminish COD of the raw wastewater, producing a biogas rich in methane, and decrease the sludge production. In the second stage, the remaining soluble biodegradable COD is oxidized by heterotrophs. In the third stage, the membrane modules could be operated at higher fluxes than those reported for AnMBR systems, and similar to those obtained in aerobic MBRs. In this sense, the concept of these three stages MBR is to join the advantages of the methanogenic and aerobic membrane bioreactor processes, by reducing energy requirements for aeration, producing biogas with high methane percentage and a permeate with very low COD content. A synthetic wastewater was fed to the three stages MBR. COD in the influent was between 200 and 1,200 mg/L, ammonium ranged from 10 to 35 mg/L and phosphorous concentration was 8 mg/L. OLR in-between 1 and 3 kg COD/(m~3 d) and a HRT of 13-21 h were applied. Temperature was between 17.5 and 23.2°C. During the whole operating period the COD removal efficiencies were in the range of 90 and 96% of which in between 40 and 80% was removed in the first methanogenic chamber. Biogas production with methane content between 75 and 80% was observed. With regard to membrane operation, average permeabilities around 150 L/(m ~2 h bar) were achieved, operating with fluxes of 11-15 L/(m ~2 h).
机译:介绍了新的三阶段MBR工艺的使用,第一阶段为产甲烷的UASB阶段,第二阶段为需氧生物膜生长在保持悬浮状态的小型载体元件上,第三阶段为膜过滤组件。第一个产甲烷室的目的是减少原废水的COD,产生富含甲烷的沼气,并减少污泥的产生。在第二阶段,剩余的可溶性可生物降解的COD被异养生物氧化。在第三阶段,膜组件可以以比AnMBR系统报告的通量更高的通量运行,与有氧MBR中获得的通量相似。从这个意义上讲,这三个阶段的MBR的概念是通过降低曝气的能源需求,产生高甲烷含量的沼气和具有非常低的COD含量的渗透物来结合产甲烷和好氧膜生物反应器工艺的优点。将合成废水进料到MBR的三个阶段。进水中的COD为200至1200 mg / L,铵的浓度为10至35 mg / L,磷浓度为8 mg / L。应用1至3 kg COD /(m〜3 d)之间的OLR和13-21 h的HRT。温度在17.5和23.2℃之间。在整个运行期间,COD去除效率在90%至96%的范围内,其中在第一个产甲烷室中去除了40%至80%的COD。观察到沼气的甲烷含量在75%至80%之间。在膜操作方面,通量为11-15 L /(m〜2 h)时,平均渗透率约为150 L /(m〜2 h bar)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号