首页> 外文期刊>Carbon: An International Journal Sponsored by the American Carbon Society >The thermotropic liquid crystalline behavior of mesophase pitches with different chemical structures
【24h】

The thermotropic liquid crystalline behavior of mesophase pitches with different chemical structures

机译:不同化学结构的中间相沥青的热致液晶行为

获取原文
获取原文并翻译 | 示例
           

摘要

Chemical structure-dependent liquid crystalline behaviors of two commercial mesophase pitches, M-AR and T-MP, which are synthesized with different raw materials of naphthalene and coal tar, respectively, were comparatively examined. The NMR analysis together with preparation procedure enabled us to suggest that M-AR consisted of linear semi-rigid molecules and T-MP, irregularly shaped rigid molecules. Between 320 and 370 °C M-AR showed marbled texture whereas T-MP, a change from schlieren/marbled to schlieren texture. WXRD results indicated that M-AR exhibited a gradual change of d_(002) and L_c with temperature but T-MP, a drastic change. A point shear stress made M-AR produce oriented flow domains but T-MP retained schlieren texture even in the oriented structure. In the temperature range producing biphase, M-AR showed a shoulder on the plot of viscosity versus temperature but T-MP, a peak. As temperature was increased M-AR gave an increase of loss tangent but a decrease of yield stress while T-MP gave a saturation point at 330 °C, at which temperature loss tangent was maximum and yield stress was minimum. Both mesophase pitches gave viscosity curves matched with the Asada-Onogi model. In the temperature range producing dispersed polydomain system, however, T-MP showed almost shear rate-independent plateau while shear-dependence was observed in M-AR.
机译:比较研究了分别用萘和煤焦油的不同原料合成的两种商业中间相沥青M-AR和T-MP的化学结构依赖性液晶行为。 NMR分析和制备程序使我们能够建议M-AR由线性半刚性分子和T-MP(不规则形状的刚性分子)组成。在320至370°C之间,M-AR表现出大理石纹,而T-MP则从schlieren /大理石纹变为schlieren质构。 WXRD结果表明,M-AR随温度呈现d_(002)和L_c的逐渐变化,而T-MP则呈现急剧变化。点剪切应力使M-AR产生定向流动域,但T-MP即使在定向结构中也保留了纹影纹理。在产生双相的温度范围内,M-AR在粘度与温度的关系图上显示出肩峰,而T-MP则显示出峰。随着温度的升高,M-AR给出了损耗角正切的增加,但屈服应力的减小,而T-MP给出了330°C的饱和点,此时温度损耗角正切最大,屈服应力最小。两种中间相沥青均给出了与Asada-Onogi模型匹配的粘度曲线。然而,在产生分散多畴系统的温度范围内,T-MP几乎表现出与剪切速率无关的平稳期,而在M-AR中观察到剪切依赖性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号