首页> 外文期刊>The European physical journal, E. Soft matter >Near-critical fluid boiling: Overheating and wetting films
【24h】

Near-critical fluid boiling: Overheating and wetting films

机译:接近临界沸腾的液体:过热和湿润的薄膜

获取原文
获取原文并翻译 | 示例
           

摘要

The heating of coexisting gas and liquid phases of pure fluid through its critical point makes the fluid extremely compressible, expandable, slows the diffusive transport, and decreases the contact angle to zero (perfect wetting by the liquid phase). We have performed experiments on near-critical fluids in a variable volume cell in the weightlessness of an orbiting space vehicle, to suppress buoyancy-driven flows and gravitational constraints on the liquid-gas interface. The high compressibility, high thermal expansion, and low thermal diffusivity lead to a pronounced adiabatic heating called the piston effect. We have directly visualized the near-critical fluid’s boundary layer response to a volume quench when the external temperature is held constant. We have found that when the system’s temperature T is increased at a constant rate past the critical temperature T c , the interior of the fluid gains a higher temperature than the hot wall (overheating). This extends previous results in temperature quenching experiments in a similarly prepared system when the gas is clearly isolated from the wall. Large elliptical wetting film distortions are also seen during these ramps. By ray tracing through the elliptically shaped wetting film, we find very thick wetting film on the walls. This wetting film is at least one order of magnitude thicker than films that form in the Earth’s gravity. The thick wetting film isolates the gas bubble from the wall allowing gas overheating to occur due to the difference in the piston effect response between gas and liquid. Remarkably, this overheating continues and actually increases when the fluid is ramped into the single-phase supercritical phase.
机译:加热纯流体并存的气相和液相到其临界点,使流体极易压缩,可膨胀,减慢了扩散传输的速度,并将接触角减小到零(液相完全润湿)。我们在轨道飞行器失重的可变体积单元中对近临界流体进行了实验,以抑制浮力驱动的液流和液-气界面上的重力约束。高压缩性,高热膨胀和低热扩散系数导致明显的绝热加热,称为活塞效应。当外部温度保持恒定时,我们直接可视化了近临界流体边界层对体积骤冷的响应。我们发现,当系统温度T以恒定速率超过临界温度T c时,流体内部的温度将高于热壁的温度(过热)。当气体与壁明显隔离时,这扩展了先前在类似制备的系统中进行温度淬火实验的结果。在这些斜坡期间,还会看到较大的椭圆形润湿膜变形。通过射线穿过椭圆形的润湿膜,我们发现墙壁上的润湿膜很厚。这种湿润的膜比地球重力形成的膜厚至少一个数量级。厚的润湿膜将气泡与壁隔离开来,由于气体和液体之间的活塞效应响应差异,会导致气体过热。值得注意的是,这种过热现象持续存在,并且在流体进入单相超临界相时实际上会增加。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号