...
首页> 外文期刊>Polymer: The International Journal for the Science and Technology of Polymers >Temperature-concentration diagram of polystyrene-block-polydimethylsiloxane associates formed in dilute solution of selective solvent
【24h】

Temperature-concentration diagram of polystyrene-block-polydimethylsiloxane associates formed in dilute solution of selective solvent

机译:在选择性溶剂的稀溶液中形成的聚苯乙烯嵌段-聚二甲基硅氧烷缔合物的温度-浓度图

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Association behaviour of polystyrene-block-polydimethylsiloxane (PS-block-PDMS) in dilute solution of selective solvent is investigated by static and dynamic light-scattering as a function of temperature and concentration. Number-average molecular weights of PS and PDMS blocks are 7.8 x 10(3) g mol(-1) and 3.2 x 10(3) g mol(-1), respectively, and the solvent is a mixture of n-octane (C8) and methylcyclohexane (MCH) with the compositions of C8/MCH = 1.23 by weight, which is selective for PDMS. On heating the solutions from 12 degrees C to 72 degrees C, three different micellar regions are observed over a concentration range of 10(-4)-10(-2) g (g of solution)(-1). The highest temperature region right below the unimer region is the so-called anomalous-micellization region, where large spherical particles are formed and prow, and eventually precipitate in a few days. In the second region at intermediate temperatures, hollow spherical micelles (vesicles) are formed with large association numbers of about 10(3). The third region is located at low temperatures and low polymer concentrations, where hollow cylindrical micelles with the estimated length/diameter ratio of less than 16 are formed. These hollow cylindrical micelles are observed on heating only, but not on cooling from the unimer region, so they are presumed not to be in equilibrium state but to be meta-stable micelles formed on micellization processes. (C) 1997 Elsevier Science Ltd. [References: 41]
机译:通过静态和动态光散射随温度和浓度的变化,研究了聚苯乙烯嵌段聚二甲基硅氧烷(PS-block-PDMS)在选择性溶剂稀溶液中的缔合行为。 PS和PDMS嵌段的数均分子量分别为7.8 x 10(3)g mol(-1)和3.2 x 10(3)g mol(-1),溶剂为正辛烷的混合物( C8)和甲基环己烷(MCH)组成,C8 / MCH = 1.23重量比,对PDMS具有选择性。在将溶液从12摄氏度加热到72摄氏度时,观察到三个不同的胶束区域,浓度范围为10(-4)-10(-2)g(每克溶液)(-1)。单体区域正下方的最高温度区域是所谓的异常胶束化区域,在该区域中形成并散布了大的球形颗粒,并最终在几天内沉淀。在中间温度的第二区域中,形成具有约10(3)的大缔合数的中空球形胶束(囊泡)。第三区域位于低温和低聚合物浓度下,在其中形成估计长度/直径比小于16的空心圆柱形胶束。这些中空的圆柱状胶束仅在加热时观察到,而在从单体区域冷却时未观察到,因此推测它们不是处于平衡状态,而是在胶束化过程中形成的亚稳态胶束。 (C)1997 Elsevier Science Ltd. [参考:41]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号