Study on vacuum induction brazing of SiC_p /LY12 composite using Al-Cu-Si-Mg filler metal

摘要

The vacuum induction brazing of SiC particulate reinforced LY12 alloy matrix composite using Al-28Cu-5Si-2Mg filler metal has been carried out. The micrograph of the joint interface was observed by scanning electron microscopy. The joint strength was determined by shear tests. The results show that brazing temperature, holding time, SiC particle volume percentage and post heat treatment influence joint strength. SiC particles happen in the brazing seam and the distribution of SiC particles in the joint is not uniform. Particle-poor zones in the joint exist near the base metal, and particle concentrate zones exist in the center of the brazing seam. In addition, the failure of the composite is predominantly initiated by the rooting of SiC particle in the brazing seam and the micro-crack expanded along the brazing seam with low energy.