Behavior of Aluminum Compounds in Soft-Water Lakes Subjected to Experimental Reclamation with Polyaluminum Chloride

摘要

The research presented in this work concerns the potential aluminum load of soft-water lake ecosystems as a result of performing chemical reclamation works. On a semitechnical scale, different doses of PAC-type aluminum coagulant (polyaluminum chloride) were tested. The required doses of coagulant (on average, 11 mg Al/L) were determined based on the amount of phosphorus that is bioavailable in the lake ecosystem. The research covered the lake water, near-bottom and interstitial water, and bottom sediments of five lakes with low alkalinity (0.4-2.5 meq/L) and low calcium contents (5-35 mg Ca/L). The experiments were conducted in situ for 2 years using mesocosms with a volume of approximately 20 m(3). The effectiveness of the flocculation and sedimentation processes of coagulant flocs was closely related to changes in water pH caused by acidic coagulant application, and the corresponding transformation level ranged from 39.8 to 99.8%. In the waters of these lakes, where the alkalinity did not reach 1 meq/L, the coagulant used in doses adequate for intensive full-scale projects caused high water pollution with dissolved aluminum fractions (from 0.05 +/- 0.01 to 4.67 +/- 1.32 mg Al/L). In all lakes, the penetration of dissolved aluminum into the interstitial water of the bottom sediment was limited to the first 5-cm layer. After the application of coagulant, the aluminum content in the bottom sediments significantly increased in proportion to the amount of the PAC used (by 12-96% in terms of a 5-cm surface layer of sediment). Within 2 years of the research, solid fractions (flocks) of the coagulant moved to a depth of 5-10 cm below the bottom level. Due to high release rates of aluminum from the applied aluminum treatments, modifications to the treatment protocols are needed in soft-water lakes.