Characterization of municipal biowaste categories for their capacity to be converted into a feedstock aqueous slurry to produce methane by anaerobic digestion

摘要

Biowaste material is a good candidate for the production of energy in urban territories. The presence of undesirable or constituents mixed with the biowaste collected by municipalities makes it difficult to recycle organic matter of sufficient quality for agricultural uses. Methane production is particularly attractive for energy recovery notably because this energy vector can be distributed using the grid already in place for natural gas in many cities. Depending on the origin and biochemical composition of biowaste, methane can be produced using thermo-chemical (gasification then syngas methanation) or biological processes (anaerobic digestion). The objective of this work was to characterize the ability of biowaste to be used as a feedstock for anaerobic digestion. Based on considerations such as the quantities produced and the availability, four categories of biowaste produced in the city of Lyon were identified as potential key resources: Garden biowaste (GBW), restauration biowaste (RBW), household biowaste (HBW) and supermarkets biowaste (SMBW). Representative samples were taken from the sites of production and analyzed for parameters including biomethane potential (BMP). Each sample was then fractioned by leaching and the distribution of the BMP between the particulate fraction and the readily soluble fraction was assessed. GBW organic matter exhibited high hemicellulose content (over 81% of VS) and a low BMP which was very poorly distributed into its soluble fraction (2 NL•㎏_TS~-1). RBW, HBW and SMBW showed a much higher BMP with a strong distribution in the soluble fraction (100 NL•㎏_TS~-1). Plastic materials were found to account for up to 40% of the mass of SMBW sample. Altogether, GBW was identified as non-favorable for anaerobic digestion and recommended rather for thermochemical conversion. HBW. RBW and SMBW revealed adapted to anaerobic. Pulping was shown to be applicable in order to convert the 3 biowaste materials into a pumpable slurry with high biomethane potential.