...
首页> 外文期刊>Polish Maritime Research >THE EXPERIMENTAL IDENTIFICATION OF THE DYNAMIC COEFFICIENTS OF TWO HYDRODYNAMIC JOURNAL BEARINGS OPERATING AT CONSTANT ROTATIONAL SPEED AND UNDER NONLINEAR CONDITIONS
【24h】

THE EXPERIMENTAL IDENTIFICATION OF THE DYNAMIC COEFFICIENTS OF TWO HYDRODYNAMIC JOURNAL BEARINGS OPERATING AT CONSTANT ROTATIONAL SPEED AND UNDER NONLINEAR CONDITIONS

机译:在恒定转速和非线性条件下工作的两个水力轴颈轴承的动力学系数的实验鉴定

获取原文
获取原文并翻译 | 示例
           

摘要

Hydrodynamic bearings are commonly used in ship propulsion systems. Typically, they are calculated using numerical or experimental methods. This paper presents an experimental study through which it has been possible to estimate 24 dynamic coefficients of two hydrodynamic slide bearings operating under nonlinear conditions. During the investigation, bearing mass coefficients are identified by means of a newly developed algorithm. An impact hammer was used to excite vibration of the shaft. The approximation by means of the least squares method was applied to determine bearing dynamic coefficients. Based on the performed research, the four (i.e. two main and two cross-coupled) coefficients of stiffness, damping and mass for each bearing were obtained. The mass coefficients add up to the complex shaft weight. These values are not required for modeling dynamics of the machine because the rotor mass is usually known, however, they may serve as a good indicator to validate the correctness of the stiffness and damping coefficients determined.
机译:流体动力轴承通常用于船舶推进系统。通常,它们是使用数值或实验方法计算的。本文提出了一项实验研究,通过该研究可以估算出在非线性条件下运行的两个流体动力滑动轴承的24个动态系数。在研究过程中,轴承质量系数通过新开发的算法进行识别。使用冲击锤来激发轴的振动。采用最小二乘法进行近似确定轴承动态系数。基于进行的研究,获得了每个轴承的四个(即两个主要和两个交叉耦合)刚度,阻尼和质量系数。质量系数加起来是复杂的轴重。这些值对于机器的动力学建模不是必需的,因为通常已知转子质量,但是它们可以用作验证所确定的刚度和阻尼系数正确性的良好指标。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号