...
首页> 外文期刊>IEEE Transactions on Plasma Science >Effect of Plasma Actuator Placement on the Airfoil Efficiency at Poststall Angles of Attack
【24h】

Effect of Plasma Actuator Placement on the Airfoil Efficiency at Poststall Angles of Attack

机译:等速执行角下等离子作动器位置对翼型效率的影响

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

One of the new techniques in active flow control is the single-dielectric barrier discharge plasma actuator, which postpones the separation with external momentum injection to the boundary layer flow. In this paper, the effect of the presence of a plasma actuator on the passing flow is investigated both numerically and experimentally at a poststall angle of attack NLF0414 airfoil. These investigations are performed for a 45-cm cord NLF0414 airfoil with an incompressible 25-m/s velocity airflow, which provides a turbulent flow. Both numerical and experimental studies are done under the same conditions for two different cases: 1) no plasma actuator is located on the airfoil and 2) a plasma actuator is located on the top surface of the airfoil. Simulating the flow over the airfoil with the presence of a plasma actuator at 9.6 mm from the leading edge of the airfoil showed that the numerical distribution of the body force induced by the plasma actuator (computed using the model presented by Suzen ) is in an appropriate correlation with the experimental results. It has been also shown that the presence of the plasma actuator on the airfoil could delay the separation and subsequently increase the airfoil's efficiency. Initially, the experimental and numerical results were compared and the written code, for simulation of the body force produced by the plasma actuator was verified. Then, the effect of the plasma actuator's location on the separation's delay at different angles of attack was numerically studied. In this case, the place of the plasma actuator on the airfoil was changed and its effect on postponement of the separation point was investigated. The results show that when the actuator is placed exactly at the leading edge of the airfoil, it has the greatest influence on postponing the separation. In addition, at an angle of attack of 18$^{circ}$, it transfers the separation point from 1- to 90 mm. In addition, it results in an increase of ${sim}{100%}$ in the efficiency (the ratio of lift to drag coefficient) of the airfoil at this angle of attack.
机译:主动流控制中的一种新技术是单电介质势垒放电等离子体致动器,它通过外部动量注入将边界分离流推迟了分离。在本文中,在失速攻角NLF0414翼型上,通过数值和实验研究了等离子体致动器的存在对通过流动的影响。这些研究是针对45厘米长的NLF0414翼型进行的,该翼型具有不可压缩的25 m / s速度气流,该气流提供湍流。在两种不同情况下,在相同条件下进行了数值研究和实验研究:1)机翼上没有等离子体致动器,并且2)机翼顶面上没有等离子体致动器。在距机翼前缘9.6 mm处存在等离子作动器的情况下,模拟机翼上的流动表明,等离子作动器引起的体力的数值分布(使用Suzen 提出的模型进行计算)与实验结果具有适当的相关性。还已经表明,在翼型上存在等离子体致动器可以延迟分离并随后提高翼型的效率。最初,比较了实验结果和数值结果,并验证了用于模拟由等离子体致动器产生的体力的书面代码。然后,数值研究了等离子体致动器的位置对不同迎角下分离延迟的影响。在这种情况下,改变了等离子体致动器在翼型件上的位置,并研究了其对延迟分离点的影响。结果表明,将执行器准确地放置在机翼的前缘时,它对延迟分离的影响最大。此外,以18 <公式>的攻角,将分离点从1转移到1。 90毫米。此外,它会导致 $ {sim} {100%} $ 的效率(提升比在这个迎角下的翼型阻力系数)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号