首页> 外文期刊>Nuclear fusion >Overview of the FTU results
【24h】

Overview of the FTU results

机译:FTU结果概述

获取原文
获取原文并翻译 | 示例
       

摘要

An overview of the FTU results during the period 2003-4 is presented. A prototype ITER-relevant lower hybrid current drive (LHCD) launcher, the passive active multijunction, has been successfully tested (f = 8 GHz) showing high power handling and good coupling properties and current drive comparable to those of a conventional launcher. Effective electron and ion heating (via collisions) have been achieved with the 140 GHz ECRH systems up to 1.5 MW, as well as current drive (25 kA at n_(e0) = 8 x 10~(19) m~(-3)). The mitigation of disruptions has been studied with on-axis ECRH. Ion Bernstein wave studies have shown the importance of recycling in achieving improved confinement plasmas. Advanced tokamak scenarios are presented including repetitive pellet enhanced plasmas and electron internal transport barriers (e-ITBs). Very peaked density profiles have been achieved with a low speed vertical pellet injector located at about mid-radius on the high field side. The performance is comparable to that achieved with a high-speed horizontal pellet injector. Possible reasons for this behaviour are discussed, among them the presence of an 'MHD' drift once particles reach the q = 1 surface. The effect of peaked density profiles on confinement is discussed. Electron ITBs can be produced at high density in FTU with LHCD only and with the combined use, of LHCD and ECRH: T_(e0) = 6 keV with n_(e0) = 1.4 x 10~(20) m~(-3) and H_(97) = 1.6. Turbulence is strongly reduced. Ions are heated by collisions with ΔT_i/ T_i up to 35% showing that e-ITBs are not degraded by the electron-ion collisions. Particle pinch studies have been made at high densities in full current drive conditions where the Ware pinch plays no role. An anomalous inward pinch exists even at these high densities (n_(e0) = 1.5 x 10~(20) m~(-3)). Despite the absence of energetic particles in FTU, MHD spectroscopy has revealed high frequency modes (30-80 kHz) that might have consequences for burning plasmas.
机译:介绍了在2003-4年期间FTU结果的概述。与ITER相关的低混合电流驱动器(LHCD)原型发射器(无源有源多结)已经成功测试(f = 8 GHz),与传统发射器相比,具有高功率处理能力,良好的耦合特性和电流驱动器。使用高达1.5 MW的140 GHz ECRH系统以及电流驱动(n_(e0)= 25 xA,n_(e0)= 8 x 10〜(19)m〜(-3),已经实现了有效的电子和离子加热(通过碰撞)。 )。已经使用同轴ECRH研究了缓解干扰的方法。离子伯恩斯坦波研究表明,再循环对于实现改善的封闭等离子体具有重要意义。介绍了先进的托卡马克方案,包括重复的团粒增强等离子体和电子内部传输壁垒(e-ITB)。使用位于高磁场侧约中半径处的低速垂直药丸注入器已经实现了非常高的密度分布。该性能可与高速卧式颗粒喷射器相媲美。讨论了这种行为的可能原因,其中包括一旦粒子到达q = 1表面就会出现“ MHD”漂移。讨论了峰值密度分布对约束的影响。仅使用LHCD并结合使用LHCD和ECRH才能以FTU高密度生产电子ITB:T_(e0)= 6 keV,n_(e0)= 1.4 x 10〜(20)m〜(-3)并且H_(97)= 1.6。湍流大大减少。离子通过与ΔT_i/ T_i的碰撞而被加热到35%,这表明e-ITB不会因电子离子碰撞而降解。在全电流驱动条件下(Ware收缩不起任何作用),已经在高密度下进行了颗粒收缩研究。即使在这些高密度下(n_(e0)= 1.5 x 10〜(20)m〜(-3)),也存在异常的向内收缩。尽管FTU中没有高能粒子,但MHD光谱显示高频模式(30-80 kHz)可能会导致等离子体燃烧。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号