首页> 外文期刊>Materials science forum >Superhydrophobic coatings prepared by microano particles mixed with fluorocarbon resin
【24h】

Superhydrophobic coatings prepared by microano particles mixed with fluorocarbon resin

机译:由微米/纳米粒子与氟碳树脂混合制备的超疏水涂料

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

In this paper, single and multilayer superhydrophobic composite coatings, based on fluorocarbon resin and micro-tourmaline and nano-TiO_2 powers, were prepared by conventional air spray method. The tourmaline and TiO_2 particles were modified by fluoroalkylsilane. The wettability and marine corrosion of the coatings surfaces were investigated respectively by contact angle measurement and Electrochemical Impedance Spectroscopy (EIS) method, and their morphology was examined by Scanning Electron Microscopy (SEM). The results showed that the water contact angle of coatings was mainly controlled by the mass ratio of the fluorocarbon resin and particles. The contact angle increased with the increase of particle concentration, which reached about 156° when the mass ratio of the particles and fluorocarbon resin was 2:1 for single and multilayer composite coatings, but the impedance valve of the multilayer is higher than that of the single layer.
机译:本文采用传统的空气喷涂法制备了基于氟碳树脂,微电气石和纳米TiO_2粉末的单层和多层超疏水复合涂料。电气石和TiO_2粒子被氟代烷基硅烷改性。通过接触角测量和电化学阻抗谱(EIS)方法分别研究了涂层表面的润湿性和海洋腐蚀,并通过扫描电子显微镜(SEM)检查了它们的形貌。结果表明,涂​​层的水接触角主要由碳氟树脂与颗粒的质量比控制。接触角随颗粒浓度的增加而增加,当颗粒与碳氟树脂的质量比为2:1时,单层和多层复合涂层的接触角达到约156°,但多层的阻抗阀高于涂层的阻抗。单层。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号