首页> 外文期刊>Materials Science and Engineering. B, Solid-State Materials for Advanced Technology >Effect of Si addition to Al-8Mg alloy on the microstructure and thermo-physical properties of SiCp/Al composites prepared by pressureless infiltration
【24h】

Effect of Si addition to Al-8Mg alloy on the microstructure and thermo-physical properties of SiCp/Al composites prepared by pressureless infiltration

机译:Al-8Mg合金中添加Si对无压浸渗制备SiCp / Al复合材料的组织和热物理性能的影响

获取原文
获取原文并翻译 | 示例
           

摘要

Fifty-five volume percentage of SiCp/Al composites were prepared by pressureless infiltration to investigate the effect of Si addition to Al-8Mg alloy from 0 wt% to 18 wt% on the interfacial reaction between Al and SiC and the thermo-physical properties of the prepared composites. TEM and X-ray analysis showed that the degree of interfacial reaction decreased as the Si content increased, and that it ceased at 1273 K when the Si addition to the aluminum was greater than 12 wt%. The Si addition to Al-8Mg alloy reduced the CTE of the composites and increased their thermal conductivity (TC), but Si beyond 12 wt% led to the reduction of TC, though the CTE was lower. This is attributable to the combined action of the Si on the wettability, interfacial reaction and the TC and CTE of the matrix itself.
机译:通过无压浸渗制备了SiCp / Al复合材料的55%的体积百分比,以研究从0wt%到18wt%的Al-8Mg合金中添加Si对Al和SiC之间的界面反应以及热力学性质的影响。准备好的复合材料。 TEM和X射线分析表明,随着Si含量的增加,界面反应的程度降低,当铝中添加的Si超过12wt%时,界面反应的程度在1273 K处停止。 Al-8Mg合金中添加的Si降低了复合材料的CTE并提高了其导热系数(TC),但Si含量超过12 wt%导致TC降低,尽管CTE较低。这归因于Si对基质的润湿性,界面反应以及TC和CTE的联合作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号