首页> 外文期刊>International journal of hydrogen energy >Effect of thermo-hydrogen-treatment on the surface oxide film and the compaction temperature of Ti-47Al-2Cr-2Nb pre-alloyed powders during hot-isostatic-pressing
【24h】

Effect of thermo-hydrogen-treatment on the surface oxide film and the compaction temperature of Ti-47Al-2Cr-2Nb pre-alloyed powders during hot-isostatic-pressing

机译:热等静压过程中加氢处理对Ti-47Al-2Cr-2Nb预合金粉末的表面氧化膜和压实温度的影响

获取原文
获取原文并翻译 | 示例
       

摘要

In this study, a new hot-isostatic-pressing process was proposed, combining with the thermo-hydrogen-treatment process. Effects of hydrogen-atoms on the surface-oxide-film and the compaction-temperature of Ti-47Al-2Cr-2Nb pre-alloyed powders were investigated during hot-isostatic-pressing. Results show that the surface-oxide-film of powders of thermo-hydrogen-treatment can be effectively removed. For samples prepared by the new hot-isostatic-pressing process, the oxygen content decreased by 130 ppm and the compaction-temperature reduced by 50-100 degrees C, comparing with samples prepared by the traditional hot-isostatic-pressing process. After high-temperature vacuum annealing, the compressive fracture strength and ratio of samples prepared by the new hot-isostaticpressing process is as high as 2830 MPa and 34.5%. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.
机译:在这项研究中,结合热氢处理工艺,提出了一种新的热等静压工艺。研究了氢原子对热等静压过程中Ti-47Al-2Cr-2Nb预合金粉末的表面氧化物膜和压实温度的影响。结果表明,可以有效地去除热氢处理粉末的表面氧化膜。与传统的热等静压工艺制备的样品相比,采用新的热等静压工艺制备的样品的氧含量降低了130 ppm,压实温度降低了50-100℃。经过高温真空退火后,新的热等静压工艺制备的样品的压缩断裂强度和比值分别高达2830 MPa和34.5%。 (C)2019氢能出版物有限公司。由Elsevier Ltd.出版。保留所有权利。

著录项

  • 来源
    《International journal of hydrogen energy》 |2019年第18期|9378-9385|共8页
  • 作者单位

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

    Cent Iron & Steel Res Inst, Beijing 100081, Peoples R China;

    Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Hubei, Peoples R China;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Ti-47Al-2Cr-2Nb pre-alloyed powders; Hot-isostatic-pressing; Thermos-hydrogen-treatment;

    机译:Ti-47Al-2Cr-2Nb预合金粉末;热等静压;热氢处理;
  • 入库时间 2022-08-18 04:19:51

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号