Experimental Investigations on Particle Contamination of Masks Without Protective Pellicles During Vibration or Shipping of Mask Carriers

摘要

Extreme ultraviolet lithography (EUVL) is considered the next generation lithography to produce 32-nm feature-size or smaller. The challenge is that conventional pellicles are unavailable for protecting the EUVL masks against contaminant particles, because the EUV beam is easily absorbed by most solid materials. The masks are usually transported or stored in mask carriers. Without the protective pellicles, particles generated inside the mask carrier may deposit on the critical surface of the mask. It is therefore important to identify where the particles are generated inside the mask carrier during shipping. In this paper, two shipping carrier models of different mask holder designs were used. The mask carriers with quartz mask blanks inside were shaken manually, vibrated with a computer-controlled vibration table, or shipped via air freight. In order to simulate the EUVL mask shipping, no pellicles were used. Several online and offline particle detection techniques were employed to investigate particle generation inside the mask carrier during vibration or shipping. It was shown that particles were mostly generated at the contact points between the mask surface and the carrier element. The design of the mask-holding element in the mask carrier played an important role in reducing particle generation.