...
首页> 外文期刊>Fuel >Multifunctionality of zinc carboxylate to produce acylglycerols, free fatty acids and fatty acids methyl esters
【24h】

Multifunctionality of zinc carboxylate to produce acylglycerols, free fatty acids and fatty acids methyl esters

机译:羧酸锌的多功能性,可生产酰基甘油,游离脂肪酸和脂肪酸甲酯

获取原文
获取原文并翻译 | 示例
           

摘要

Hydrolysis of acid oils is an important alternative for the production of non-ionic surfactants and fatty acids that can be converted to fatty acid methyl esters (biodiesel) by esterification. In this work, hydrolysis of palm oil was initially carried out in subcritical water using zinc stearate as catalyst. The experiments were performed in a CSTR-type reactor where the effect of temperature (140-190 degrees C), palm oil-to-water MR (1:10-1:53) and catalyst amount (2-10 wt%) were evaluated. High contents of free fatty acids (up to 60 wt%) with 35 wt% diacylglycerols and 20 wt% monoacylglycerols were obtained. Also, zinc stearate maintained its catalytic activity for palm oil hydrolysis for five consecutive reuse cycles but changes in the catalyst chemical composition were observed, mostly due to the conversion of zinc stearate to zinc palmitate. However, by increasing the reaction time from 4 to 8 h at 190 degrees C, there was a decrease in the accumulation of free fatty acids and an increase in the accumulation of acylglycerols and this was a strong evidence for reaction reversion. After removal of water, palm oil hydrolysates still containing the reaction catalyst were subjected to simultaneous esterification and transesterification under similar reaction conditions, reaching a final monoester content of about 90 wt%. These values are 50 wt% higher than those obtained by direct transesterification using the same catalyst. Also, the resulting crude glycerin phase was colorless in appearance, indicating little contamination with reaction products and intermediates.
机译:酸油的水解是生产非离子型表面活性剂和脂肪酸的重要替代方法,这些非离子表面活性剂和脂肪酸可通过酯化转化为脂肪酸甲酯(生物柴油)。在这项工作中,棕榈油的水解最初是在硬脂酸锌为催化剂的亚临界水中进行的。实验在CSTR型反应器中进行,其中温度(140-190摄氏度),棕榈油-水MR(1:10-1:53)和催化剂量(2-10 wt%)的影响为评估。获得了高含量的游离脂肪酸(最多60 wt%)以及35 wt%的二酰基甘油和20 wt%的单酰基甘油。另外,硬脂酸锌在五个连续的再利用循环中保持了其对棕榈油水解的催化活性,但是观察到催化剂化学组成的变化,这主要是由于硬脂酸锌向棕榈酸锌的转化。但是,通过在190℃下将反应时间从4 h增加到8 h,游离脂肪酸的积累减少了,酰基甘油的积累增加了,这是反应逆转的有力证据。除去水后,仍包含反应催化剂的棕榈油水解产物在相似的反应条件下同时进行酯化和酯交换反应,最终单酯含量约为90wt%。这些值比使用相同催化剂的直接酯交换反应所获得的值高50重量%。而且,所得粗制甘油相在外观上是无色的,表明反应产物和中间体几乎没有污染。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号