首页> 外文期刊>Energy & fuels >Synthesis Gas Production from Partial Oxidation of Methane with Air in AC Electric Gas Discharge
【24h】

Synthesis Gas Production from Partial Oxidation of Methane with Air in AC Electric Gas Discharge

机译:交流电放电中甲烷与空气部分氧化制合成气

获取原文
获取原文并翻译 | 示例
           

摘要

In this study, synthesis gas production in an AC electric gas discharge of methane and air mixtures at room temperature and ambient pressure was investigated. The objective of this work was to understand how the CH_4/O_2 feed mole ratio, ethane added, diluent gas, residence time, input power, applied frequency, and waveform, affected methane and oxygen conversions, product selectivities, and specific energy consumption. Methane and oxygen conversions increased with input power but decreased with increasing CH_4/O_2 feed mole ratio, flow rate, and gap distance. The experiments were performed at the frequency and power in the range of 200―700 Hz and 8―14 W, respectively, while the residence times were varied from 0.06 to 0.46 s. This study confirms that active oxygen is an important factor in enhancing methane conversion and energy efficiency in a discharge reactor. Ethane is the primary product that forms at short residence times and low energies. Methane conversion dropped dramatically but oxygen conversion increased with addition of ethane to the feed gas. Sinusoidal and square waveforms gave negligibly different results. Current was constant with varying CH_4/O_2 ratio and flow rate, but increased with increasing power and with decreasing gap distance and frequency. It was shown that the best condition was at 300 Hz and at the highest power used in each condition, since the maximum methane and oxygen conversions and synthesis gas selectivity as well as lowest specific energy consumption were found both with and without ethane in the feed gas. The minimum specific energy consumption, found at 300 Hz, were 21 and 14 eV/m_c for the CH_4/air system and the CH_4air/C_2H_6 system, respectively. When studying the effect of residence time by varying the flow rate, the minimum energy consumption of 21 eV/m_c was found at 0.12 and 0.23 s. For any given input power or frequency, the CH_4/air system had a higher specific energy consumption than the CH_4/air/C_2H_6 system. Less energy was consumed to convert methane under the plasma environment with nitrogen as a diluent compared to helium, indicative of a third body effect.
机译:在这项研究中,研究了在室温和环境压力下甲烷和空气混合物的交流电放电中合成气的产生。这项工作的目的是了解CH_4 / O_2进料的摩尔比,乙烷的添加量,稀释气体,停留时间,输入功率,施加的频率和波形如何影响甲烷和氧气的转化率,产物的选择性和比能耗。甲烷和氧气的转化率随输入功率的增加而增加,但随着CH_4 / O_2进料摩尔比,流速和间隙距离的增加而降低。实验分别在200-700 Hz和8-14 W的频率和功率下进行,而停留时间从0.06到0.46 s不等。这项研究证实,活性氧是提高放电反应器中甲烷转化率和能源效率的重要因素。乙烷是在短停留时间和低能量下形成的主要产物。甲烷转化率急剧下降,但是随着乙烷加入到进料气中,氧气转化率增加。正弦波和方波的结果几乎可以忽略不计。电流随CH_4 / O_2比率和流速的变化而恒定,但随着功率的增加以及间隙距离和频率的减小而增加。结果表明,最佳条件是在300 Hz且每种条件下使用的最高功率,因为​​在进料气中有或没有乙烷的情况下,甲烷和氧气的转化率最高,合成气选择性最高,单位能耗最低。 CH_4 / air系统和CH_4air / C_2H_6系统在300 Hz处的最小比能耗分别为21和14 eV / m_c。当通过改变流速研究停留时间的影响时,发现最小能量消耗为21 eV / m_c,分别为0.12和0.23 s。对于任何给定的输入功率或频率,CH_4 /空气系统比CH_4 / air / C_2H_6系统具有更高的比能耗。与氦气相比,在等离子体环境下以氮气作为稀释剂转化甲烷所消耗的能量更少,这表明存在第三种人体效应。

著录项

  • 来源
    《Energy & fuels》 |2003年第2期|p.474-481|共8页
  • 作者单位

    The Petroleum and Petrochemical College, Chulalongkorn University, Bangkok 10330, Thailand;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 TK-;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号