...
首页> 外文期刊>Critical care : >Revisiting the loading dose of amikacin for patients with severe sepsis and septic shock
【24h】

Revisiting the loading dose of amikacin for patients with severe sepsis and septic shock

机译:重度脓毒症和脓毒性休克患者的阿米卡星负荷量

获取原文
           

摘要

IntroductionIt has been proposed that doses of amikacin of >15 mg/kg should be used in conditions associated with an increased volume of distribution (Vd), such as severe sepsis and septic shock. The primary aim of this study was to determine whether 25 mg/kg (total body weight) of amikacin is an adequate loading dose for these patients.MethodsThis was an open, prospective, multicenter study in four Belgian intensive care units (ICUs). All consecutive patients with a diagnosis of severe sepsis or septic shock, in whom amikacin treatment was indicated, were included in the study.ResultsIn 74 patients, serum samples were collected before (t = 0 h) and 1 hour (peak), 1 hour 30 minutes, 4 hours 30 minutes, 8 hours, and 24 hours after the first dose of amikacin. Blood amikacin levels were measured by using a validated fluorescence polarization immunoassay method, and an open two-compartment model with first-order elimination was fitted to concentrations-versus-time data for amikacin (WinNonlin). In 52 (70%) patients, peak serum concentrations were >64 μg/ml, which corresponds to 8 times the clinical minimal inhibitory concentration (MIC) breakpoints defined by EUCAST for Enterobacteriaceae and Pseudomonas aeruginosa (S16 μg/ml). Vd was 0.41 (0.29 to 0.51) L/kg; elimination half-life, 4.6 (3.2 to 7.8) hours; and total clearance, 1.98 (1.28 to 3.54) ml/min/kg. No correlation was found between the amikacin peak and any clinical or hemodynamic variable.ConclusionsAs patients with severe sepsis and septic shock have an increased Vd, a first dose of ≥ 25 mg/kg (total body weight) of amikacin is required to reach therapeutic peak concentrations. However, even with this higher amikacin dose, the peak concentration remained below therapeutic target levels in about one third of these patients. Optimizing aminoglycoside therapy should be achieved by tight serum-concentration monitoring because of the wide interindividual variability of pharmacokinetic abnormalities.
机译:引言有人建议,在与分布量(Vd)增加有关的情况下(例如严重的败血症和败血性休克)应使用大于15 mg / kg的阿米卡星剂量。这项研究的主要目的是确定25 mg / kg(总体重)的丁胺卡那汀是否适合这些患者。方法这是一项在四个比利时重症监护病房(ICU)中进行的开放,前瞻性,多中心研究。结果所有74例确诊为严重败血症或败血性休克的患者均接受了丁胺卡那霉素治疗。结果74例患者在(t = 0 h)和1小时(peak),1小时(1 h)采集了血清样本首次服用丁胺卡那霉素后30分钟,4小时,30分钟,8小时和24小时。通过使用经过验证的荧光偏振免疫分析方法测量血液中的丁胺卡那霉素水平,并将具有一阶消除的开放式两室模型拟合丁胺卡那霉素的浓度-时间数据(WinNonlin)。在52名(70%)患者中,峰值血清浓度> 64μg/ ml,相当于EUCAST为肠杆菌科和铜绿假单胞菌(S16μg/ ml)定义的临床最小抑菌浓度(MIC)临界点的8倍。 Vd为0.41(0.29至0.51)L / kg;消除半衰期为4.6(3.2至7.8)小时;总清除率为1.98(1.28至3.54)ml / min / kg。阿米卡星峰值与任何临床或血液动力学变量之间均无相关性。结论由于严重脓毒症和败血性休克患者的Vd升高,需要达到≥25 mg / kg(总体重)的第一剂量阿米卡星才能达到治疗峰值浓度。但是,即使使用较高的丁胺卡那霉素剂量,这些患者中约有三分之一的峰值浓度仍低于治疗目标水平。由于药代动力学异常的个体差异较大,因此应通过严格的血清浓度监测来实现最佳的氨基糖苷治疗。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号