首页> 外文期刊>Chemical and Biochemical Engineering Quarterly >Enhancement of the Growth of Marine Microalga Chlorella sp. from Mixotrophic Perfusion Cultivation for Biodiesel Production
【24h】

Enhancement of the Growth of Marine Microalga Chlorella sp. from Mixotrophic Perfusion Cultivation for Biodiesel Production

机译:海洋微藻小球藻菌种生长的增强。混合营养培养物中的生物柴油生产

获取原文
           

摘要

Abstract For biodiesel production, marine alga Chlorella sp. was grown by continuously perfusing 35–40 °C warm waste seawater in a 14 L photobioreactor. The temperature of the culture system was maintained at minimum of 25 °C at 1.0 L h–1 of perfusion rate with no other heating systems. Under mixotrophic conditions with only 1 g L–1 of glucose, a maximum cell concentration of 7.1 (gdry mass L–1) was observed for over 95 days cultivation while 3.3 (gdry mass L–1) of maximum cell concentration was maintained for autotrophic growth. The highest total lipid production was also obtained as w = 21.6 % with w = 50 % of palmitic and oleic acids, which would be a proper composition for biodiesel. The specific lipid production rate remained relatively constant until the end of the perfusion cultivation while it decreased in latter periods of batch cultivation. In general, the perfusion process shows a better performance because of the continuous supply of fresh medium and high accumulation of biomass. These results prove that this unique recycling system can be employed where geographically the temperature is a more critical factor for outdoor mass cultivation.
机译:摘要对于生物柴油生产,海藻小球藻属。通过在14 L光生物反应器中连续灌注35–40°C的温暖废海水来生长。在没有其他加热系统的情况下,以1.0 L h-1的灌注速率将培养系统的温度保持在最低25°C。在只有1 g L–1葡萄糖的混合营养条件下,在超过95天的培养中观察到最大细胞浓度为7.1(干质量L–1),而自养营养的最大细胞浓度保持为3.3(干质量L-1)。增长。当w = 50%的棕榈酸和油酸时,w = 21.6%时,也可获得最高的总脂质产量,这将是生物柴油的合适组成。直到灌注培养结束时,比脂的产生速率保持相对恒定,而在分批培养的后期则降低。通常,由于连续供应新鲜培养基和高生物量积累,灌注过程表现出更好的性能。这些结果证明,这种独特的回收系统可以在地理上对于室外大规模栽培更为关键的因素中使用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号