Pullout capacity of ladder-type metal reinforcements in tire shred-sand mixtures

摘要

Tire shreds have gained wide acceptance as an engineered fill in the last two decades. Ladder-type metal reinforcement can be used to reinforce MSE walls with tire shred-sand mixtures as a backfill material. This paper reports the results of laboratory pullout testing performed on ladder-type metal reinforcement embedded in tire shred-sand mixtures. The ladder-type metal reinforcement consists of two parallel longitudinal steel bars welded to a series of cross bars forming rectangular apertures. Mixtures of Ottawa sand with 50-100 mm size tire shreds were prepared at different mixing ratios (0%, 20%, 25%, and 35% by weight of tire shreds). Pullout tests were performed under three normal stresses - 40 kPa, 65 kPa, and 90 kPa. The test results show that the ladder-type metal reinforcement provides higher pullout resistance in tire shred-sand mixtures than in sand alone. Compared to metal-strip reinforcement, ladder-type metal reinforcement provides higher pullout capacity due to the passive resistance that results from the interlocking of tire shreds within the grids of the ladder-type reinforcement. The pullout resistance increased with increasing tire shred content up to 35% (by weight of tire shreds), beyond which segregation of the mixtures was observed. (C) 2016 Elsevier Ltd. All rights reserved.