首页> 外文期刊>Combustion and Flame >Combustion mechanism of composite solid propellant sandwiches containing nano-aluminium
【24h】

Combustion mechanism of composite solid propellant sandwiches containing nano-aluminium

机译:含铝纳米复合固体推进剂三明治的燃烧机理

获取原文
获取原文并翻译 | 示例
           

摘要

Combustion of sandwiches made of alternating laminae of ammonium perchlorate (AP) and a matrix of hydrocarbon binder mixed with fine AP and nano-aluminium particles is considered in the 1-12 MPa pressure range. Companion non-aluminized sandwiches are studied for comparison. The nano-Al particles are produced from the electrical wire explosion process in the size range similar to 45 nm, and added to the matrix containing either 5 or 45 mu m AP particles. Three categories of middle lamina thicknesses thin (100-170 mu m), intermediate (200-280 mu m), and thick (370-480 mu m) are examined in all the sandwiches. High-speed high-magnification imaging of the combustion is performed, and surface profiles and features of quenched sandwiches are investigated, besides burning rate measurements. The sandwich burning rates are compared with those of the corresponding matrices and AP laminae burning alone as well. The results imply the close location of lamina leading edge flames (L-LEFs) over the lamina interface edges, leaving the outer AP laminae inclined steeply relative to the matrix middle lamina, in the nano aluminized cases relative to the non-aluminized versions. This observation suggests that the L-LEFs control the burning rates of the sandwiches even in the case of the fast burning matrix that contains nano-Al. The non-aluminized sandwiches containing the 5 mu m AP show higher burning rates than their 45 pm AP counterparts because of the enhanced heat feedback available to the matrix burning surface from the extended fuel-rich branches of adjacent L-LEFs in the former case. Therefore, the enhancement in burning rate is minimal with the inclusion of nano-Al in sandwiches with smaller fine AP size, whereas the nano-aluminized sandwiches containing larger fine AP particles exhibit such enhancement. These effects affirm previous results on propellants with smaller fine and coarse AP sizes, where the burning rate is not enhanced by nano-Al. (C) 2017 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
机译:认为在1-12 MPa的压力范围内,由高氯酸铵(AP)的层流和碳氢化合物基质与细微的AP和纳米铝颗粒混合而成的三明治的燃烧。研究了伴侣非铝化三明治。纳米Al粒子是由电线爆炸过程产生的,其尺寸范围类似于45 nm,并添加到包含5或45μmAP粒子的基质中。在所有三明治中检查了三类中间薄板厚度:薄(100-170微米),中(200-280微米)和厚(370-480微米)。进行了燃烧的高速高倍成像,除了测量燃烧速率外,还研究了淬火三明治的表面轮廓和特征。将三明治的燃烧速率与相应矩阵的燃烧速率进行比较,还单独将AP薄片燃烧。结果表明,在纳米镀铝的情况下,相对于非铝化的版本,层状前沿火焰(L-LEF)在层界面边缘上的位置很近,而使外部AP层相对于基质中间层陡峭倾斜。该观察结果表明,即使在包含纳米Al的快速燃烧基体的情况下,L-LEF也可以控制三明治的燃烧速率。含有5微米AP的未铝化三明治显示出比45 pm AP更高的燃烧速率,这是因为在前一种情况下,相邻L-LEF的富燃料分支延长了基质燃烧表面的热反馈。因此,在细小的AP尺寸较小的三明治中加入纳米Al可以最大程度地降低燃烧速率,而细小的AP颗粒较大的纳米铝化三明治则表现出这种增强。这些效应证实了具有较小细粉和粗粉AP尺寸的推进剂的先前结果,其中纳米Al不能提高燃烧速率。 (C)2017燃烧研究所。由Elsevier Inc.出版。保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号