首页> 外文期刊>Combustion and Flame >Investigation into pressure dependence of flame speed for fuels with low and high octane sensitivity through blending ethanol
【24h】

Investigation into pressure dependence of flame speed for fuels with low and high octane sensitivity through blending ethanol

机译:通过混合乙醇对低辛辛和高辛烷值敏感燃料的压力依赖性的调查

获取原文
获取原文并翻译 | 示例
       

摘要

Spark assistance for homogeneous charge compression ignition (HCCI) can control combustion phasing, improve thermal efficiency, and reduce emissions in gasoline engines. As the characteristics of flame propagation determine the control authority of ignition timing, it is important and necessary to investigate pressure dependence of flame speed in the lean-premixed mixture relative to engine operating conditions. Experimental study in an optical rapid compression machine (RCM) and simulation work were carried out using two fuels comprising n-heptane/iso-octane/ethanol with varied octane sensitivity (S). The effective pressure ranged from 10 to 35 bar, temperature from 715 to 860 K, and equivalence ratios between 0.3 and 0.7 to cover the region of lean flammability limits of low and high S fuels with ethanol blended. Based on pressure profiles, flame speed extracted from images, and sensitivity analysis of flame speed, the dependence of flame speed on the effective pressure in low and high S fuels was discovered and the fundamental mechanism behind this phenomena became to be understood in the negative temperature coefficient (NTC) and non-NTC regions, respectively. In the studied temperature conditions, the flame speed of high S fuel has stronger dependence on the pressure than that of low S fuel does. In the NTC region, this phenomenon is attributed to the dependence of H radical concentration on pressure in the unburned mixture and flame structure. In the non-NTC region, promoting effect of dominant reactions varied with pressure can significantly influence pressure dependence of flame speed. Although quite limited data of laminar burning velocity for studied fuels were obtained in high pressures (15 bar), the trend of flame speed's dependence on pressure was well predicted by two models with different but well-accepted core mechanisms, showing consistent results with the experimental ones in the RCM. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
机译:用于均匀电荷压缩点火(HCCI)的火花辅助可以控制燃烧相位,提高热效率,减少汽油发动机的排放。随着火焰传播的特性确定点火正时的控制权,重要的是研究火焰速度相对于发动机操作条件的稀薄混合物的压力依赖性。光学快速压缩机(RCM)和模拟工作中的实验研究使用包含具有不同辛烷敏感性的正庚烷/异辛烷/乙醇的两种燃料进行。有效压力范围为10至35巴,温度为715至860 k,同等比率在0.3和0.7之间,以覆盖乙醇混合的低和高S燃料的稀燃度限制区域。基于压力型材,从图像中提取的火焰速度,并对火焰速度的灵敏度分析,发现火焰速度对低和高S燃料的有效压力的依赖性,并且在负温度下理解这种现象背后的基本机制变得明显系数(NTC)和非NTC区域。在研究的温度条件下,高S燃料的火焰速度与低于低S燃料的压力较强依赖。在NTC区域中,这种现象归因于H激烈浓度对未燃烧混合物和火焰结构的压力的依赖性。在非NTC区域中,促进主体反应的促进变化的效果可以显着影响火焰速度的压力依赖性。尽管在高压(> 15巴)中获得了用于研究燃料的层流燃烧速度的相当有限的数据,但火焰速度对压力依赖的趋势是通过不同但很好地接受的核心机制的两种模型预测的,显示结果一致实验中的RCM。 (c)2019燃烧研究所。由elsevier Inc.出版的所有权利保留。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号