首页> 外文期刊>Circuits and Systems II: Express Briefs, IEEE Transactions on >Model Order Reduction Based on Dynamic Relative Gain Array for MIMO Systems
【24h】

Model Order Reduction Based on Dynamic Relative Gain Array for MIMO Systems

机译:基于MIMO系统动态相对增益阵列的模型顺序

获取原文
获取原文并翻译 | 示例
           

摘要

The computational efficiency of traditional model order reduction (MOR) methods may degrade sharply for multi-input multi-output (MIMO) systems especially when the number of ports of MIMO systems is very large. During the concrete computation process, many input-output pairs can be ignored due to the weak interactions to each other, and hence the efficiency of reduction can be improved by reducing the number of ports. In this brief, we develop a dynamic relative gain array (DRGA) method to decide which inputs are important enough to an output in the MOR process. The DRGA method is based on the state feedback predictive control, and both the steady state information and the dynamic information are considered in the process of loop pairing. Multi-input single-output (MISO) subsystems can be obtained from decoupling the original large MIMO system. Experimental results on RLC networks show that the proposed DRGA based MOR method has higher accuracy compared with the passive reduced-order interconnect macromodeling (PRIMA) method, the decentralized model order reduction (DeMOR) method, and the balance truncation reduction (BTR) method.
机译:传统模型顺序减少(MOR)方法的计算效率可能急剧地降低多输入多输出(MIMO)系统,特别是当MIMO系统的端口数量非常大时。在具体计算过程中,由于彼此的弱相互作用,许多输入输出对可以忽略,因此可以通过减少端口数来提高减少效率。在此简介中,我们开发了一种动态的相对增益阵列(DRGA)方法来确定哪些输入足以让MOR过程中的输出。 DRGA方法基于状态反馈预测控制,并且在环路配对过程中考虑稳态信息和动态信息。可以通过解耦原始大型MIMO系统来获得多输入单输出(MISO)子系统。 RLC网络上的实验结果表明,与被动依次互连宏观调(PRIMA)方法,分散式模型顺序减少(上光)方法和平衡截断减少(BTR)方法相比,该基于DRGA的MOR方法具有更高的精度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号