首页> 外文期刊>Applied Surface Science >Nano-structure and optical properties (plasmonic) of graded helical square tower-like (terraced) Mn sculptured thin films
【24h】

Nano-structure and optical properties (plasmonic) of graded helical square tower-like (terraced) Mn sculptured thin films

机译:渐变螺旋方塔状(梯形)Mn雕刻薄膜的纳米结构和光学性质(等离激元)

获取原文
获取原文并翻译 | 示例
       

摘要

Graded helical square tower-like terraced sculptured Mn thin films (GHSTTS) are produced in three stages with different number of arms using oblique angle deposition together with rotation of substrate holder about its surface normal, plus a shadowing block fixed at the centre of the substrate holder. The structural characterization of the produced samples was obtained using field emission scanning electron microscope (FESEM) and atomic force microscope (AFM). Results showed a structural gradient with distance from the edge of the shadowing block, which in turn is responsible for the decrease in the volume of void fraction and increase of grain size. Plasmon absorption peaks observed in the optical analysis of these nano-structures showed that their wavelength region and intensity depend on the polarization and the incident angle of light, as well as the distance from the edge of the shadowing block. According to our model and discrete dipole approximation (DDA) calculations, when the number of parallel nano-rods of different lengths and radii are increased the peak in the spectrum shifts to shorter wavelengths (blue shift). Also when the diameters of the nano-rods increases (a situation that occurs with increasing film thickness) the results is again a blue shift in the spectrum. The presence of defects in these sculptured structures caused by the shadowing effect is predicted by the theoretical DDA investigation of their optical spectra. Good agreement is obtained between our theoretical results and the experimental observations in this work. (C) 2016 Elsevier B.V. All rights reserved.
机译:通过倾斜角度沉积以及衬底支架围绕其表面法线的旋转以及在衬底中心固定的遮挡块,分三步生产带有不同臂数的渐变螺旋方形塔状梯状Mn薄膜(GHSTTS)持有人。使用场发射扫描电子显微镜(FESEM)和原子力显微镜(AFM)获得了所生产样品的结构特征。结果表明,随着距遮挡块边缘的距离逐渐增大,结构梯度逐渐减小,这又导致空隙率的降低和晶粒尺寸的增大。在这些纳米结构的光学分析中观察到的等离子吸收峰表明,它们的波长范围和强度取决于光的偏振和入射角以及与遮蔽边缘的距离。根据我们的模型和离散偶极近似(DDA)计算,当增加不同长度和半径的平行纳米棒的数量时,光谱中的峰值将移至较短的波长(蓝移)。同样,当纳米棒的直径增加时(随着膜厚度增加而发生的情况),结果再次是光谱中的蓝移。通过阴影效应的理论DDA研究,可以预测由阴影效应导致的这些雕塑结构中缺陷的存在。我们的理论结果与这项工作中的实验观察之间取得了很好的一致性。 (C)2016 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号