首页> 外文期刊>Applied Energy >Experimental study and numerical simulation on in-cylinder flow of small motorcycle engine
【24h】

Experimental study and numerical simulation on in-cylinder flow of small motorcycle engine

机译:小型摩托车发动机缸内流动的实验研究与数值模拟

获取原文
获取原文并翻译 | 示例
           

摘要

This study aimed at experimental and numerically investigating in-cylinder flows of a small motorcycle engine under steady-state conditions. The experiment was conducted in the engine head for a variety of fixed valve lifts at two pressure drops (300 and 600 mmH(2)O). Besides, this study attempted to analyze the characteristics of in-cylinder flows in a small engine by applying CFD methods. Looking at the results, there was a good agreement between the results of experiment and simulation in terms of flow coefficient, air flow rate and discharge coefficient at two pressure drops. In both horizontal and vertical planes, both increased valve lift and pressure drop delivered increased velocity and vorticity magnitude. An increase in pressure drop at the beginning of valve lift opening appeared to have no effect on the swirl ratio until the valve lift reached 5 mm. However, the swirl ratio got a 25% reduction when the valve lift reached 6.25 mm. An increase in pressure drop at the intake stroke did not deliver a significant effect on the tumble ratio and accumulated air mass. However, the accumulated air mass increased 3.77% at compression stroke. An increase in pressure drop delivered a significant effect on turbulent kinetic energy (TKE), turbulent length scale and turbulent kinematic viscosity. TKE reached its peak (200%) at 470 degrees CA, while turbulent length scale and turbulent kinematic viscosity reached their peaks at 590 degrees CA where the intake valve was almost closed. The increase in turbulence in fact produced a more homogeneous in-cylinder air-fuel mixing. Besides, the increase in turbulence directly increased the rate of fire propagation. Further study would be expected to focus on modifying the design of intake port for improving the air flow characteristics of small engines. Then, this study was expected to reduce the number of experiments required for investigating optimized parameters in small engines.
机译:这项研究旨在对小型摩托车发动机在稳态条件下的缸内流动进行实验和数值研究。该实验是在两个不同的压降(分别为300和600 mmH(2)O)下在各种固定气门升程的发动机盖上进行的。此外,本研究试图通过使用CFD方法分析小型发动机的缸内流动特性。从结果看,在两个压降下的流量系数,空气流速和排放系数方面,实验结果与模拟结果之间有很好的一致性。在水平和垂直平面上,增加的气门升程和压降都增加了速度和涡度。直到气门升程达到5 mm之前,在气门升程打开开始时压降的增加似乎对旋流比没有影响。但是,当气门升程达到6.25 mm时,涡流比降低了25%。进气冲程的压降增加并未对滚动比和累积空气质量产生明显影响。但是,在压缩冲程中,累积的空气质量增加了3.77%。压降的增加对湍动能(TKE),湍流尺度和湍流运动粘度产生了显着影响。 TKE在470度CA达到峰值(200%),而湍流尺度和湍流运动粘度在590度CA达到峰值,此时进气门几乎关闭。实际上,湍流的增加产生了更均匀的缸内空气-燃料混合。此外,湍流的增加直接增加了火势蔓延的速度。预计将进行进一步的研究,以改进进气口的设计以改善小型发动机的空气流动特性。然后,该研究有望减少研究小型发动机中优化参数所需的实验次数。

著录项

  • 来源
    《Applied Energy》 |2019年第1期|113863.1-113863.19|共19页
  • 作者单位

    Univ Ulsan Grad Sch Mech Engn San 29 Mugeo2 Dong Ulsan 44610 South Korea|Indonesian Inst Sci Res Ctr Elect Power & Mechatron Jl Cisitu 154-21D Bandung 40135 Indonesia;

    Univ Ulsan Grad Sch Mech Engn San 29 Mugeo2 Dong Ulsan 44610 South Korea;

    Univ Ulsan Sch Mech Engn San 29 Mugeo2 Dong Ulsan 44610 South Korea;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    Small engine; In-cylinder flow; Steady-state flow; Pressure drop;

    机译:小型发动机;缸内流量;稳态流;压力下降;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号