首页> 美国卫生研究院文献>Biophysical Journal >General continuum analysis of transport through pores. II. Nonuniform pores.
【2h】

General continuum analysis of transport through pores. II. Nonuniform pores.

机译:通过孔的运输的一般连续性分析。二。毛孔不均匀。

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

A general continuum derivation of the nonelectrolyte (Js) and volume (Jv) flux through a pore whose cross section is a function of axial position (nonuniform) is given. In general, the flux equations cannot be reduced to the same form as for a uniform pore and it is not possible to characterize the pore kinetics by three constants as in the uniform pore case. However, it is shown that under certain conditions, the nonuniform pore equations can be approximated by the uniform pore form and can be characterized by three constants (omega, sigma, Lp). The only condition needed to reduce the Jv equation to the uniform form is that the solution be dilute. The deviation of the Js equation from the uniform form is characterized by an asymmetrical function of Jv whose maximum value is estimated. It is shown that the maximum posible fractional deviation of the Js equation from the uniform form is given by the parameter: 0:5sigmaJv/omegaRT. Since this parameter is less then 0.15 for most membrane studies, the nonuniform Js equation can usually be approximated by the uniform pore form. The general results are illustrated by explicit calculations on several models of nonuniform pores. It is shown, for example, that the "equivalent pore radius" defined in the usual way is a function of the experimental parameter that is measured and is not unique.
机译:给出了通过孔的非电解质(Js)和体积(Jv)通量的一般连续性推导,该孔的横截面是轴向位置(不均匀)的函数。通常,通量方程不能简化为与均匀孔隙相同的形式,并且不可能像均匀孔隙情况那样通过三个常数来表征孔隙动力学。然而,已经表明,在某些条件下,非均匀孔隙方程可以由均匀孔隙形式近似,并且可以由三个常数(ω,σ,Lp)表征。将Jv方程简化为均匀形式所需的唯一条件是溶液应稀释。 Js方程与均匀形式的偏差的特征在于Jv的不对称函数,其最大值被估计。结果表明,Js方程与均匀形式的最大可能分数偏差由参数:0:5sigmaJv / omegaRT给出。由于对于大多数膜研究,该参数小于0.15,因此通常可以通过均匀的孔形式来近似非均匀的Js方程。通过对不均匀孔的几种模型进行显式计算可以说明总体结果。例如,表明以通常方式定义的“等效孔半径”是所测量的实验参数的函数,并且不是唯一的。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号