首页> 外文学位 >Novel technologies for cardiovascular monitoring using ballistocardiography and electrocardiography.
【24h】

Novel technologies for cardiovascular monitoring using ballistocardiography and electrocardiography.

机译:使用心动描记法和心电图术进行心血管监测的新技术。

获取原文
获取原文并翻译 | 示例

摘要

More than 5,000,000 Americans suffer from heart failure, a progressive disorder where the heart cannot meet the metabolic demands of the tissues and organs. Approximately 1.5 million hospitalizations each year are related to heart failure in the US. After release from the hospital, the American Heart Association recommends monitoring heart failure patients at home by measuring body weight daily---upward trends of more than a few pounds could indicate edema, and the need for rehospitalization. Recently, in addition to simply monitoring weight, many researchers have investigated new devices for monitoring hemodynamics in the home to reduce unnecessary rehospitalizations.;This work proposes measuring both body weight and hemodynamics on the same device: a modified bathroom scale. Body weight measurement on a scale is straightforward; for hemodynamic monitoring, a combination of ballistocardiography and electrocardiography sensing technologies were developed.;When a patient stands on the scale, small fluctuations in body weight caused by the heartbeat---the ballistocardiogram (BCG)---are measured and related to the strength of cardiac contractions. Furthermore, while standing on the scale, a patient grips detachable handlebar electrodes, allowing simultaneous measurement of an electrocardiogram (ECG) signal. These two signals were fused using a novel estimation algorithm, and the BCG signal was reconstructed from the recorded waveform composed of both signal and measurement noise, such as motion artifacts.;To further improve robustness to motion, electromyogram (EMG) signals acquired from the subject's feet were recorded, and the correlation between the EMG power and the BCG noise was investigated. Floor vibrations represent another source of interference, and were mitigated by using a seismic sensor on the floor next to the scale and an adaptive algorithm. Using this approach, BCG recordings were obtained on a parked bus with the engine running---even under such extreme conditions the vibration interference was effectively eliminated.;With this system, normal standards at rest were established for 92 healthy subjects. The timing and amplitude features of the signal were found to be comparable to those measured using cumbersome bed- or table-based BCG measurement systems. Frequency domain features were also explored: the power spectral density of the BCG signal was estimated and characterized. A correlation analysis yielded that features of the BCG signal combined with height and weight were correlated to left ventricular mass (R2 = 0.60, p 0.001) and stroke volume (R2 = 0.60, p 0.01), two important cardiovascular parameters estimated using echocardiography. The correlation to left ventricular mass is an especially encouraging result, as the system could potentially be used in large scale screening of athletes for hypertrophy.;After establishing standards at rest, the hemodynamics were modulated to determine the capability of the system to detect changes in cardiac output. For 10 trials involving nine healthy subjects, each subject exercised for 15 minutes then recovered while standing on the scale for 10 minutes. During the recovery, the gold standard for noninvasive cardiac output estimation---Doppler echocardiography---was used to measure this parameter repeatedly. The changes in cardiac output measured by Doppler were strongly correlated to the changes in root mean square (RMS) power of the BCG (R2 = 0.85, n = 275 data points, p 0.001). The prediction error, calculated based on Bland-Altman methods, was found to be lower than any other noninvasive method disclosed to date.;With this technology, heart failure patients could monitor both weight gain and cardiac output at home on the same device: an inexpensive, compact, modified commercial weighing scale. The subject compliance would be excellent, since the device is already a commonly-used household item and does not require anything to be attached to the body. By using the BCG/ECG-equipped weighing scale every day for less than 15 seconds at a time, unnecessary rehospitalizations could decrease, improving the quality of care for the large population of heart failure patients.
机译:超过5,000,000的美国人患有心力衰竭,这是一种进行性疾病,心脏无法满足组织和器官的代谢需求。在美国,每年大约有150万例住院与心力衰竭有关。从医院出院后,美国心脏协会建议每天通过测量体重在家中监测心力衰竭患者-超过几磅的上升趋势可能表示水肿,需要重新住院。最近,除了简单地监测体重外,许多研究人员还研究了用于监测家庭血液动力学的新设备,以减少不必要的再次住院。这项工作建议在同一设备上测量体重和血液动力学:改良的浴室秤。体重秤的测量很简单;为了进行血流动力学监测,开发了心搏描记法和心电描记术传感技术的组合;当患者站立在体重秤上时,可以测量由心跳引起的体重的微小波动-心动描记图(BCG)-并将其与心脏收缩的强度。此外,病人站立在秤上时,会抓住可拆卸的车把电极,从而可以同时测量心电图(ECG)信号。使用新颖的估计算法将这两个信号融合在一起,然后从记录的由信号和测量噪声(例如运动伪影)组成的波形中重建BCG信号;为了进一步提高运动的鲁棒性,从肌电图获得的肌电图(EMG)信号记录受试者的脚,并研究EMG功率与BCG噪声之间的相关性。地板振动是另一种干扰源,通过在地板上使用电子秤旁边的地震感应器和自适应算法可以减轻振动。使用这种方法,可以在发动机运转的情况下在停放的公交车上获得BCG记录-即使在这种极端条件下也可以有效消除振动干扰。通过该系统,可以为92名健康受试者建立正常的静息标准。发现信号的时序和幅度特征与使用繁琐的基于床或表的BCG测量系统所测量的特征相当。还探索了频域特征:估计并表征了BCG信号的功率谱密度。相关分析表明,BCG信号的特征与身高和体重相结合与左心室质量(R2 = 0.60,p <0.001)和中风量(R2 = 0.60,p <0.01)(使用超声心动图估计的两个重要心血管参数)相关。与左心室质量的相关性是一个特别令人鼓舞的结果,因为该系统可以潜在地用于运动员的肥大性筛查。;建立静止标准后,调节血液动力学以确定系统检测血脂变化的能力。心输出量。对于涉及9位健康受试者的10个试验,每个受试者运动15分钟,然后在体重秤上站立10分钟,然后恢复。在恢复过程中,采用无创心输出量估计的金标准-多普勒超声心动图-反复测量该参数。多普勒测得的心输出量变化与BCG的均方根(RMS)功率变化密切相关(R2 = 0.85,n = 275个数据点,p <0.001)。发现基于Bland-Altman方法计算出的预测误差低于迄今为止公开的任何其他非侵入性方法。借助这种技术,心力衰竭患者可以在同一设备上在家中监测体重增加和心输出量:便宜,紧凑,改良的商业秤。因为该设备已经是一种常用的家用物品,并且不需要任何东西附着在身体上,所以其符合性极好。通过每天使用配备BCG / ECG的体重秤一次少于15秒,可以减少不必要的重新住院,从而改善了大量心力衰竭患者的护理质量。

著录项

  • 作者

    Inan, Omer Tolga.;

  • 作者单位

    Stanford University.;

  • 授予单位 Stanford University.;
  • 学科 Engineering Biomedical.;Engineering Electronics and Electrical.;Biology Physiology.
  • 学位 Ph.D.
  • 年度 2009
  • 页码 166 p.
  • 总页数 166
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号