首页> 外文学位 >Ultrahigh vacuum metalorganic chemical vapor deposition and in situ characterization of nanoscale titanium dioxide films.
【24h】

Ultrahigh vacuum metalorganic chemical vapor deposition and in situ characterization of nanoscale titanium dioxide films.

机译:超高真空金属有机化学气相沉积和纳米级二氧化钛薄膜的原位表征。

获取原文
获取原文并翻译 | 示例

摘要

Thin titanium dioxide films were produced by metalorganic chemical vapor deposition on sapphire(0001) in an ultrahigh vacuum (UHV) chamber. A method was developed for producing controlled submonolayer depositions from titanium isopropoxide precursor. Film thickness ranged from 0.1 to 2.7 nm. In situ X-ray photoelectron spectroscopy (XPS) was used to determine film stoichiometry with increasing thickness. The effect of isothermal annealing on desorption was evaluated. Photoelectron peak shapes and positions from the initial monolayers were analyzed for evidence of interface reaction.; Deposition from titanium isopropoxide is divided into two regimes: depositions below and above the pyrolysis temperature. This temperature was determined to be 300{dollar}spcirc{dollar}C. Controlled submonolayers of titanium oxide were produced by cycles of dosing with titanium isopropoxide vapor below and annealing above 300{dollar}spcirc{dollar}C. Precursor adsorption below the pyrolysis temperature was observed to saturate after 15 minutes of dosing. The quantity absorbed was shown to have an upper limit of one monolayer. The stoichiometry of thin films grown by the cycling method were determined to be TiO{dollar}sb2{dollar}.; Titanium dioxide film stoichiometry was unaffected by isothermal annealing at 700{dollar}spcirc{dollar}C. Annealing produced a decrease in film thickness. This was explained as due to desorption. Desorption ceased at approximately 2.5 to 3 monolayers, suggesting bonding of the initial monolayers of film to sapphire is stronger than to itself.; Evidence of sapphire reduction at the interface by the depositions was not observed. The XPS O 1s peak shifted with increased film thickness. The shifts were consistent with oxygen in sapphire and titanium dioxide having different O 1s photoelectron peak positions. Simulations showed the total shifts for thin films ranging in thickness of 0.1 to 2.7 nm to be {dollar}-{dollar}0.99 to {dollar}-{dollar}1.23 eV. Thick films were produced for comparison. Total shifts were {dollar}-{dollar}1.07 to {dollar}-{dollar}1.19 eV for thick films ranging from 0.1 to 0.15 {dollar}mu{dollar}m; these films were grown by continuous depositions above the pyrolysis temperature.
机译:通过在超高真空(UHV)腔室中在蓝宝石(0001)上进行金属有机化学气相沉积来生产二氧化钛薄膜。开发了一种从异丙醇钛前体生产可控的亚单层沉积的方法。膜厚度为0.1至2.7nm。原位X射线光电子能谱(XPS)用于确定随着厚度增​​加的薄膜化学计量。评估了等温退火对脱附的影响。分析了来自初始单层的光电子峰的形状和位置,以发现界面反应的证据。异丙醇钛的沉积分为两个过程:热解温度以下和以上的沉积。该温度被确定为300sp美元。可控的亚单层氧化钛是通过在低于300℃的异丙醇钛蒸汽和高于300℃的退火温度下加药循环而产生的。在给药15分钟后,观察到低于热解温度的前体吸附饱和。显示吸收量具有单层的上限。通过循环法生长的薄膜的化学计量被确定为TiO {美元} sb2 {美元}。二氧化钛膜的化学计量不受在700 sp C的等温退火的影响。退火使膜厚度减小。这被解释为由于解吸。解吸在大约2.5到3个单层停止,表明膜的初始单层与蓝宝石之间的结合强于其自身。没有观察到通过沉积在界面处蓝宝石减少的证据。 XPS O 1s峰随膜厚度的增加而移动。位移与蓝宝石中的氧气和具有不同O 1s光电子峰位置的二氧化钛一致。模拟显示,厚度在0.1至2.7 nm范围内的薄膜的总位移为{dollar}-{dollar} 0.99至{dollar}-{dollar} 1.23 eV。产生厚膜用于比较。对于0.1至0.15 {μm}μm{dollar} m的厚膜,总位移为{dollar}-{dollar} 1.07至{dollar}-{dollar} 1.19eV;这些膜通过在热解温度以上的连续沉积而生长。

著录项

  • 作者

    Chu, Polly Wanda.;

  • 作者单位

    Cornell University.;

  • 授予单位 Cornell University.;
  • 学科 Engineering Materials Science.
  • 学位 Ph.D.
  • 年度 1994
  • 页码 213 p.
  • 总页数 213
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 工程材料学;
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号