首页> 外文学位 >Experimental investigation of thermodynamic and kinetic properties of semi-volatile organic aerosols.
【24h】

Experimental investigation of thermodynamic and kinetic properties of semi-volatile organic aerosols.

机译:半挥发性有机气溶胶热力学和动力学性质的实验研究。

获取原文
获取原文并翻译 | 示例

摘要

We have developed and applied novel experimental techniques for determination of thermodynamic and kinetic properties of semi-volatile organic aerosols. The thermodynamic properties investigated were the saturation pressure ( Psat), enthalpy of vaporization (DeltaH) and activity coefficient (gamma), and the kinetic property was the evaporation coefficient (alpha).;The thermodynamic properties were determined using the integrated volume method (IVM), which relies on measurements of aerosol particle concentrations at different thermodynamic equilibrium states. The measured decrease in particle concentration upon heating in a flow tube, a thermodenuder, can be correlated with Psat and DeltaH via the IVM equation, which was derived from fundamental principles, namely the Clausius-Clapeyron relation, mass conservation, and ideal gas law. The main advantage of the IVM over other methods reported in the literature is that the other methods use kinetic-based techniques to measure thermodynamic properties which require assumptions on the usually unknown evaporation coefficient; the IVM, on the other hand, is equilibrium-based and thus requires no assumption on the evaporation coefficient. We have applied the IVM to C-4, -6, -7, and -9 dicarboxylic acid aerosols, which are pertinent to atmospheric secondary organic aerosols. Psat and DeltaH values obtained for these compounds were respectively 3.7x10-4 Pa and 88 kJ/mol, 3.4x10-5 Pa and 135 kJ/mol, 7.2x10 -5 Pa and 149 kJ/mol, and 1.4x10-5 Pa and 145 kJ/mol.;The IVM was also used to determine activity coefficients of individual compounds in binary mixtures as a function of their mole fractions. We demonstrated this method using the following four model systems. System 1: adipic acid-pimelic acid, which illustrated polar organic-polar organic interactions. Non-ideal behavior was observed with activity coefficients of approximately three at infinite dilution. System 2: adipic acid-dioctyl sebacate, which illustrated polar organic-non-polar organic interactions. The compounds in this experiment did not form a solution. System 3: adipic acid-ammonium sulfate, which illustrates polar organic-inorganic interactions. The compounds in this experiment did not form a solution. System 4: adipic acid-ambient extracts, which illustrated the potential use of the method to study partitioning behavior of individual components in a complex matrix approximating that of real ambient aerosol. The measured activity coefficient of adipic acid was less than unity for the tested range of mixing ratios, indicating suppression of volatility of this compound in ambient organic matrix.;We have investigated three controversial issues associated with the IVM as well as other methods which utilize thermodenuders and/or aerosol generation by spray atomization and drying: (1) equilibration time scales in thermodenuders, (2) the need for an activated carbon (AC) denuder in the cooling section, and (3) the effect of residual solvent on measured thermodynamic properties of aerosols generated by spray atomization and drying. Both numerical simulations and experiments showed that the aerosols approached equilibrium within reasonable residence times (15 s -- 30 s) for aerosol size distributions typical for laboratory measurements. We have also performed dimensional analysis on the problem of equilibration in TDs, and derived a dimensionless equilibration parameter which can be used to determine the residence time needed for an aerosol of given sized distribution and kinetic properties to approach equilibrium. Using both model simulations and experiments, we have shown that with aerosol size distributions relevant to both ambient and laboratory measurements recondensation in the cooling section, with and without an AC denuder, was negligible. Thus, there is no significant benefit in using an AC denuder in the cooling section. To investigate the effect of residual solvent on measured thermodynamic properties, we compared measurements of Psat and DeltaH of C-6 (adipic) and C-9 (azelaic) dicarboxylic acid aerosols generated by atomization of aqueous solutions to those generated by homogeneous condensation using a modified Sinclair-La Mer generator. We found no statistically significant difference between the tested aerosol generation methods, indicating that residual solvent carried by the particles had no impact on the measurements.;To determine the evaporation coefficient, we developed the integrated volume-tandem differential mobility analysis (IV-TDMA) method. This thermodenuder-based method allows separate determination of the three parameters governing aerosol evaporation, namely, Psat, surface free energy (sigma), and alpha. Psat was determined using the IVM, while alpha and sigma were determined by fitting particle evaporation rates measured under non-equilibrium conditions to a numerical model of the evaporation process. alpha was determined in a size range where surface free energy effects were negligible, allowing for single parameter optimization. We obtained alpha and sigma values of 0.07 and 0.15 J/m2, 0.08 and 0.17 J/m2 and 0.24 and 0.23 J/m2 for C-4, -6, and -7 dicarboxylic acids, respectively.
机译:我们已经开发并应用了新颖的实验技术来测定半挥发性有机气溶胶的热力学和动力学特性。研究的热力学性质为饱和压力(Psat),汽化焓(DeltaH)和活度系数(γ),动力学性质为蒸发系数(α).;使用积分体积法(IVM)确定热力学性质),这取决于在不同热力学平衡状态下测量气溶胶颗粒浓度。可以通过IVM方程将测得的在流管(热剥蚀器)中加热时颗粒浓度的降低与Psat和DeltaH关联,该方程是从基本原理得出的,即克劳修斯-克拉珀龙关系,质量守恒和理想气体定律。与文献中报道的其他方法相比,IVM的主要优势在于,其他方法使用基于动力学的技术来测量热力学性质,这需要对通常未知的蒸发系数进行假设。另一方面,IVM是基于平衡的,因此不需要假设蒸发系数。我们已将IVM应用于C-4,-6,-7和-9二羧酸气雾剂,它们与大气中的次级有机气雾剂有关。这些化合物的Psat和DeltaH值分别为3.7x10-4 Pa和88 kJ / mol,3.4x10-5 Pa和135 kJ / mol,7.2x10 -5 Pa和149 kJ / mol和1.4x10-5 Pa和145 kJ / mol。; IVM还用于确定二元混合物中单个化合物的活度系数,该系数是其摩尔分数的函数。我们使用以下四个模型系统演示了此方法。系统1:己二酸-庚二酸,说明了极性有机-极性有机相互作用。在无限稀释下观察到非理想行为,其活度系数约为3。系统2:己二酸-癸二酸二辛酯,它说明了极性有机物-非极性有机物的相互作用。该实验中的化合物未形成溶液。系统3:己二酸-硫酸铵,说明了极性的有机-无机相互作用。该实验中的化合物未形成溶液。系统4:己二酸-环境提取物,说明了该方法潜在的用途,可用于研究复杂基质中各个组分的分配行为,逼近实际环境中的气溶胶。在混合比的测试范围内,测得的己二酸活度系数小于1,表明该化合物在环境有机基质中的挥发性得到抑制。;我们研究了与IVM相关的三个有争议的问题以及其他利用热剥蚀剂的方法和/或通过喷雾雾化和干燥产生气雾剂:(1)热剥蚀器中的平衡时间刻度;(2)冷却段中需要使用活性炭(AC)剥蚀器;(3)残留溶剂对测得的热力学的影响喷雾雾化和干燥产生的气溶胶的特性。数值模拟和实验均表明,对于实验室测量中典型的气溶胶尺寸分布,气溶胶在合理的停留时间内(15 s-30 s)达到了平衡。我们还对TD中的平衡问题进行了尺寸分析,并得出了无量纲的平衡参数,该参数可用于确定给定尺寸分布的气溶胶和达到平衡所需的动力学特性所需的停留时间。通过模型模拟和实验,我们已经表明,与环境和实验室测量相关的气溶胶尺寸分布,在有无AC剥蚀器的情况下,冷却区的再冷凝是微不足道的。因此,在冷却段中使用交流电剥蚀器没有明显的好处。为了研究残留溶剂对测得的热力学性质的影响,我们比较了通过水溶液雾化生成的C-6(己二酸)和C-9(壬二酸)二羧酸气溶胶的Psat和DeltaH的测量值,以及使用H2O进行均相缩合生成的值。改良的Sinclair-La Mer发电机。我们发现测试的气溶胶生成方法之间没有统计学上的显着差异,表明颗粒所携带的残留溶剂对测量值没有影响。为了确定蒸发系数,我们开发了积分体积串联差动迁移率分析(IV-TDMA)方法。这种基于热剥蚀剂的方法允许分别确定控制气溶胶蒸发的三个参数,即Psat,表面自由能(sigma)和alpha。使用IVM确定Psat,而α和σ是通过将在非平衡条件下测得的颗粒蒸发速率与蒸发过程的数值模型拟合而确定的。在表面自由能影响可忽略的尺寸范围内确定α,从而可以进行单参数优化。对于C-4,-6和-7二元羧酸,我们分别获得0.07和0.15 J / m2、0.08和0.17 J / m2以及0.24和0.23 J / m2的alpha和sigma值。

著录项

  • 作者

    Saleh, Rawad.;

  • 作者单位

    Duke University.;

  • 授予单位 Duke University.;
  • 学科 Engineering Environmental.
  • 学位 Ph.D.
  • 年度 2010
  • 页码 148 p.
  • 总页数 148
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号