首页> 外文学位 >AFM studies on detailed structures and dynamic growth of crystals in BA-Cn polymer films.
【24h】

AFM studies on detailed structures and dynamic growth of crystals in BA-Cn polymer films.

机译:AFM研究BA-Cn聚合物薄膜中晶体的详细结构和动态生长。

获取原文
获取原文并翻译 | 示例

摘要

Using AFM, detailed structures and dynamic growth of crystals in films of poly(bisphenol A alkyl ether) (BA-Cn) (n = 6, 8, 10, 12) were studied. Several important fundamental issues have been addressed.; Regarding the construction of spherulites through continuous lamellar branching and splaying, three mechanisms for branching were proposed and confirmed: (1) screw dislocations; (2) induced nucleation of partially trapped polymer chains in the parent lamellae; (3) stresses induced by the crystallization of the parent lamellae in their nearby regions. It was found that a relatively small range of branching (splaying) angles between daughter and parent lamellae is necessary for the formation of spherulites.; Totally different from traditional banded spherulites, a novel self-organized crystalline structure containing concentric rings (or bands) was presented. This concentric-ringed crystalline structure consists of crystals only with the flat-on orientation. The formation of a depletion zone due to specific volume decrement between the crystal and the melt and the diffusion of polymer chains to the fold surface of the flat-on lamellae were found to lead to the formation of the structure. A model for the formation of the concentric-ringed crystalline structure was proposed.; Surface crystallization of polymer films at temperatures below bulk Tg of the polymer was observed at (near) the film surface, revealing that the polymer/air and polymer/substrate interfaces in the supported polymer films play dominant roles in the crystallization behavior within films. On the one hand, due to the requirement of small surface energy of the system, edge-on and flat-on nuclei (lamellae) are preferred at the polymer/air and polymer/substrate interfaces, respectively. On the other hand, crystallization in films is initiated and accelerated by the presence of the polymer/air and polymer/substrate interfaces.; The consistency of AFM observations compared with conventional OM results in both crystal growth kinetics and morphologies was tested. Because the well-known Lauritzen-Hoffman theory was found not to be the best mode to use to analyze the cold crystallization of BA-Cn (n = 8) polymer, a new expression for lamellar growth kinetics was proposed based on a simple kinetic model---attachment-and-detachment of crystallization units onto the crystal rough surfaces without the secondary nucleation step during crystallization.
机译:使用原子力显微镜,研究了聚(双酚A烷基醚)(BA-Cn)(n = 6,8,10,12)薄膜中晶体的详细结构和晶体的动态生长。已经解决了几个重要的基本问题。关于通过连续的层状分支和张开构造球晶,提出并证实了三种分支机理:(1)螺钉脱位; (2)诱导母体片中部分捕获的聚合物链成核; (3)母片在其附近区域结晶所引起的应力。已经发现,在球状片和母片之间的相对较小的分支角(张开角)是必需的。完全不同于传统的带状球晶,提出了一种包含同心环(或带)的新型自组织晶体结构。这种同心环状的晶体结构仅由平坦取向的晶体组成。发现由于晶体和熔体之间的特定体积减少而导致的耗尽区的形成,以及聚合物链向扁平薄片的折叠表面的扩散导致了结构的形成。提出了形成同心环状晶体结构的模型。在膜表面附近(接近)观察到聚合物膜在低于聚合物的体温Tg的温度下表面结晶,这表明负载的聚合物膜中的聚合物/空气和聚合物/基材界面在膜内的结晶行为中起主要作用。一方面,由于要求系统具有较小的表面能,因此在聚合物/空气和聚合物/底物的界面处分别优选边缘上的核和平坦上的核(薄片)。另一方面,由于聚合物/空气和聚合物/底物界面的存在,薄膜的结晶开始并加速。测试了AFM观察结果与常规OM结果在晶体生长动力学和形态方面的一致性。由于发现众所周知的Lauritzen-Hoffman理论不是用于分析BA-Cn(n = 8)聚合物冷结晶的最佳方式,因此基于简单的动力学模型提出了层状生长动力学的新表达式。 -在结晶过程中没有第二成核步骤的情况下,将结晶单元附着和分离到晶体粗糙表面上。

著录项

  • 作者

    Wang, Yong.;

  • 作者单位

    Hong Kong University of Science and Technology (Hong Kong).;

  • 授予单位 Hong Kong University of Science and Technology (Hong Kong).;
  • 学科 Chemistry Polymer.
  • 学位 Ph.D.
  • 年度 2006
  • 页码 298 p.
  • 总页数 298
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类 高分子化学(高聚物);
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号