首页> 外文会议>UK-Europe-China Workshop on Millimeter Waves and Terahertz Technologies >A 24GHz CMOS LC-VCO with tuned push-pull buffer amplifier
【24h】

A 24GHz CMOS LC-VCO with tuned push-pull buffer amplifier

机译:具有调谐推挽缓冲放大器的24GHz CMOS LC-VCO

获取原文

摘要

A low power, area-efficiency differential push-pull buffer amplifier with tuned output for mm-wave LC-VCO was presented in this paper. The push-pull technique is introduced to the differential LC-tuned buffer amplifier to increase the trans-conductor without increasing the power dissipation. Moreover, the proposed amplifier needs only one resonator tank for differential tuned outputs and such circuit topology can significantly reduce chip area. A 24GHz LC-VCO with digitally tuned varactor array for coarse tuning was also presented as part of the LO generator. Since the output frequency of the VCO is divided into several sub-curves, digitally tuned varactor array is also adopted to the tuned buffer amplifier and synchronized switched with those in LC-VCO to keep up the center frequency of the resonator tank. The designed VCO with the proposed buffer amplifier was implemented in 90nm CMOS process and occupies an area of 480um × 450um. It covers a frequency range from 23.7GHz to 25.2GHz and the measured phase noise is −116dBc/Hz@10MHz at 24GHz output.
机译:本文提出了一种针对毫米波LC-VCO进行调谐输出的低功耗,面积效率高的差分推挽缓冲放大器。推挽技术被引入到差分LC调谐缓冲放大器中,以增加跨导而不增加功耗。而且,所提出的放大器仅需要一个谐振器储能器用于差分调谐输出,并且这种电路拓扑可以显着减小芯片面积。作为LO发生器的一部分,还展示了带有数字调谐变容二极管阵列的24GHz LC-VCO,用于粗调。由于VCO的输出频率分为几个子曲线,因此调谐缓冲放大器还采用了数字调谐变容二极管阵列,并与LC-VCO中的开关进行同步切换,以保持谐振腔的中心频率。采用建议的缓冲放大器设计的VCO是在90nm CMOS工艺中实现的,占地面积为480um×450um。它覆盖23.7GHz至25.2GHz的频率范围,在24GHz输出时测得的相位噪声为−116dBc / Hz @ 10MHz。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号