FEA of BTA Beep Hole Drilling Based on ANSYS

摘要

This paper takes BTA deep hole drilling as the research object.ANSYS software is used in the static and dynamic analysis of the force of BTA deep hole drilling process from theory and in modeling and simulation.Firstly,According to the finite element analysis,the most concentrated stress and the largest deformation of the cutting tool are the cutting edge and the cutting surface of the tool block.The main vibration of drill stem is in the form of twist and bending.Sceondly,it is concluded that the main vibration of drill stem is in the form of twist and bending through the modal analysis.Finally,the natural frequency of this type of BTA drill stem is obtained by analyzing the amplitude response curve,and it is suggested to avoid the rotational speed near the dangerous speed during machining to avoid resonance of the drill stem.