Study of the Influence of Conditions of Combined Casting and Rolling- Extruding and Two-Stage Annealing on the Structure and Properties of Semi-Finished Electrical Products from an Al-Zr System Alloy

摘要

This article presents the results of the study of the joint effect of the processing conditions of the new composition of the Al-Zr system alloy by combined casting and rolling-extruding and two-stage annealing on the structure and properties of round bars used in the manufacture of heat-resistant wires. The research show patterns of changes in the properties, the specific electrical resistance of the bars, depending on different conditions of deformation and heat treatment of aluminum alloy with a content of 0.3% zirconium and 0.2% iron. The results of micro-X-ray spectral analysis and the granular structure of the samples before and after two-stage annealing confirming the stability of the structure after heating and preserving the strength of semifinished products. Presented parameters of combined casting and rolling-extruding and two-stage annealing for the manufacture of rods from the studied alloy make it possible obtaining good combination of mechanical properties and electrical conductivity.