首页> 外文会议>SPE Western Regional Meeting >An Analysis of Cyclic Steam Stimulation Projects in the California Opal A Diatomite
【24h】

An Analysis of Cyclic Steam Stimulation Projects in the California Opal A Diatomite

机译:加州甘氨酸甘氨酸循环蒸汽刺激项目分析

获取原文

摘要

Cyclic steam stimulation (CSS) in the California Opal A diatomite has been a successful commercial oil recovery technique since the 1990s. This paper analyzes the production performance of several California CSS diatomite projects comparing actual and calculated steam-oil ratios, SOR, as a function of oil recovery to ascertain whether a project is performing up to its full potential. SORs are computed using simplified Buckley-Leverett fractional flow theory applied to steam injection. SOR, or its reciprocal oil-steam ratio (OSR), have always been useful qualitative indicators of CSS project performance; but have not been used to optimize production performance other than to say operators should strive to keep the SOR low, or the OSR high. We show that an SOR equal to about 1 is what a CSS diatomite project should achieve through the recovery of about 20% of the oil-in-place, or more, to yield the highest oil production for a given set of conditions. A corresponding “optimum” steam injection rate is discussed. Projects that are managed this way have the highest average oil production rate per well and the lowest instantaneous SOR. This study shows that steam over-injection in the diatomite is common even when the injected cold water equivalent (CWE) steam is “in balance” with the oil and water that are produced. Although not discussed in detail, we postulate that the low permeability diatomite has an inherent low rate of heat absorption compared to other oil bearing rocks that can cause too much vapor to accumulate around the well when steam injection becomes excessive. Relative permeability effects develop during flow back that give way to (a) the preferential flow of steam to the producer and (b) constrained re-saturation of the heated zone. Avoiding this tendency helps insure good project performance including high oil flow rates and high oil recovery. Although the calculation method we discuss is used for CSS in the low permeability diatomite, it should be helpful in all CSS applications. Improving CSS steam practices will have the added benefit of lowering the carbon intensity of the oil that is produced. Our analysis uses published data for the needed input parameters including information from the California Division of Oil, Gas and Geothermal Resources (DOGGR) internet web data base.
机译:加利福尼亚州的循环蒸汽刺激(CSS)在20世纪90年代以来,硅藻土的硅藻土一直是成功的商业石油恢复技术。本文分析了若干加州CSS硅藻土项目的生产性能,比较实际和计算的蒸汽油比,SOR,作为石油恢复的函数,以确定项目是否达到其全部潜力。使用应用于蒸汽喷射的简化巴克利 - Leverett分数流动理论来计算SORS。 SOR或其互惠蒸汽比(OSR),始终是CSS项目性能的有用定性指标;但尚未用于优化生产性能,除了说操作员应该努力保持索焦度,或者OSR高。我们表明SOR等于约1的是CSS硅藻土项目应通过恢复约20%的燃油或更多,以产生给定条件集的最高油生产。讨论了相应的“最佳”蒸汽喷射速率。以这种方式管理的项目具有每井平均油生产率最高,最低的瞬间SOR。该研究表明,即使喷射的冷水当量(CWE)蒸汽与生产的油和水“平衡”,硅藻土中的蒸汽过度注射也很常见。尽管未详细讨论,但与其他油轴承岩石相比,我们假设低渗透性硅藻土具有固有的低吸热速率,当蒸汽喷射变得过度时可能导致太多蒸汽堆积圆顶。相对渗透效应在流回到期间发育,使得(a)蒸汽的优先流量和(b)被加热区的重新饱和度约束。避免这种趋势有助于确保良好的项目性能,包括高油流量和高油回收。虽然我们讨论的计算方法用于低渗透性硅藻土中的CSS,但它应该有助于所有CSS应用。改善CSS蒸汽实践将增加降低生产的油的碳强度的增加的益处。我们的分析使用了所需的输入参数的已发布数据,包括来自加利福尼亚州石油,天然气和地热资源(Doggr)互联网数据库的信息。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号