首页> 外文会议>SAE World Congress and Exhibition >Determination of the R Factor for Fuel Economy Calculations Using Ethanol-Blended Fuels over Two Test Cycles
【24h】

Determination of the R Factor for Fuel Economy Calculations Using Ethanol-Blended Fuels over Two Test Cycles

机译:两种试验循环中乙醇共混燃料的燃料经济性计算的R因子的测定

获取原文

摘要

During the 1980s, the U.S. Environmental Protection Agency (EPA) incorporated the R factor into fuel economy calculations in order to address concerns about the impacts of test fuel property variations on corporate average fuel economy (CAFE) compliance, which is determined using the Federal Test Procedure (FTP) and Highway Fuel Economy Test (HFET) cycles. The R factor is defined as the ratio of the percent change in fuel economy to the percent change in volumetric heating value for tests conducted using two differing fuels. At the time the R-factor was devised, tests using representative vehicles initially indicated that an appropriate value for the R factor was 0.6. Reassessing the R factor has recently come under renewed interest after EPA's March 2013 proposal to adjust the properties of certification gasoline to contain significant amounts of ethanol. This proposed change will likely result in a significant deviation from the CAFE baseline test fuel heating value, and thus increased importance of the R factor. This paper reports on the analysis of fuel economy data from three relatively large vehicle studies recently conducted using ethanol-blended fuels; the analysis determines the value of R for Tier-1 and Tier-2 compliant vehicles. These data sets include the DOE Intermediate Ethanol Blends Immediate Effects Study, the EPAct/V2/E-89 project results, and the DOE Intermediate Ethanol Blends Catalyst Durability Program. The Immediate Effects Study and EPAct test program yielded measurements for R of 0.891±0.075 and 0.921±0.010, respectively for the LA92 drive cycle. Both studies using the LA92 cycle observed a tendency for the R value to rise for E15 and E20 fuels. The results of the DOE Intermediate Ethanol Catalyst Durability Program produced an average R factor of 0.949±0.041 for the FTP cycle. Increasing fuel ethanol content did not have a significant effect on FTP R factor values for the FTP cycle.
机译:在20世纪80年代,美国环境保护局(EPA)将R因素纳入燃料经济性计算,以解决关于使用联邦测试确定的对企业平均燃料经济性(CAFE)符合性的测试燃料性能变化影响的担忧程序(FTP)和公路燃料经济性试验(HFET)循环。 R因子被定义为使用两个不同燃料进行的测试的燃料经济性变化百分比与体积加热值变化的比率。在设计R因子时,使用代表性车辆的测试最初表明R因子的适当值为0.6。重新评估r因素最近在EPA 3月3日在2013年3月调整认证汽油属性以含有大量乙醇的建议之后获得的重新兴趣。这一提出的变化可能导致咖啡馆基线测试燃料加热值的显着偏差,从而增加了R因子的重要性。本文报告了使用乙醇共混燃料最近进行的三种相对大型车辆研究的燃料经济性数据的分析;分析确定了Tier-1和Tier-2兼容车辆的r的值。这些数据集包括DOE中间乙醇混合即时效果研究,弹簧/ v2 / E-89项目结果,以及DOE中间体乙醇共混催化剂耐久性计划。即时效果研究和膜的测试程序分别为LA92驱动循环产生0.891±0.075和0.921±0.010的测量。使用LA92循环的两项研究观察到r值升高E15和E20燃料的趋势。为FTP循环产生DOE中间乙醇催化剂耐久性计划的平均R系数为0.949±0.041。增加燃料乙醇含量对FTP循环的FTP r因子值没有显着影响。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号