首页> 外文会议>Annual Stapp Car Crash Conference >Biomechanical investigation of airbag-induced, upper-extremity injuries
【24h】

Biomechanical investigation of airbag-induced, upper-extremity injuries

机译:气囊诱导的生物力学调查,上肢损伤

获取原文

摘要

The factors that influence airbag-induced, upper-extremity injuries sustained by drivers were investigated in this study. Seven unembalmed human cadavers were used in nineteen direct-forearm-interaction static deployments. A single horizontal-tear-seam airbag module and two different inflators were used. Spacing between the instrumented forearm and the airbag module was varied from 10 cm to direct contact in some tests. Forearm-bone instrumentation included triaxial accelerometry, crack detection gages, and film targets. Internal airbag pressure was also measured. The observed injuries were largely transverse, oblique, and wedge fractures of the ulna or radius, or both, similar to those reported in field investigations. Tears of the elbow joint capsule were also found, both with and without fracture of the forearm. Forearm fracture occurrence was analyzed with respect to time of airbag deployment, distal forearm speed, airbag-module-to-forearm spacing, bone mineral content, and upper-extremity mass. Forearm fractures occurred within 5 to 10 ms of the onset of airbag pressure, as indicated by crack detection gage output. Time of fracture was found to coincide with local reductions in resultant distal forearm acceleration, and local plateaus of distal forearm speed. Peak distal forearm speed ranged from 9 to 21 m/s, and decreased approximately 30 percent when initial airbag-module-to-forearm spacing was increased from direct contact to 2.5 cm. A distinct division between fracture and nonfracture cases was found at about 15.2 m/s peak, and 11.7 m/s average, distal forearm speed. Distal forearm speed, fracture incidence, and fracture severity were typically reduced as initial airbag-module-to-forearm spacing was increased. Additionally, under direct-contact conditions, fractures occurred in bones having mineral contents less than 1.03 g/cm, but not in bones having greater mineral contents. Both distal forearm speed and mineral content were found to be strongly related to the mass of the upper extremity. Therefore, the potential for forearm fracture was also found to be strongly related to the mass of the upper extremity. The results of this study suggest that airbag-module-to-forearm spacing has a substantial influence on airbag-induced, upper-extremity injuries sustained by drivers. Increased initial spacing between the airbag module and the forearm reduces the incidence and severity of forearm fractures caused by direct interaction with the airbag. Furthermore, increased initial spacing reduces the speeds ultimately achieved by the distal forearm, thereby potentially mitigating flailing injuries. The results also suggest that a simple airbag agressivity-assessment tool for the prediction of forearm fracture might be based upon peak or average distal forearm speed of a biofidelic, surrogate arm.
机译:在这项研究中调查了影响安全气囊诱导的上肢损伤的因素。七个Unemaled人尸体用于19名直叉互动静态部署。使用单个水平撕裂缝气囊模块和两种不同的充气机。仪表式前臂和安全气囊模块之间的间距在10cm之间变化以在一些测试中直接接触。前臂 - 骨仪器包括三轴加速度,裂纹检测测量和薄膜目标。还测量内部安全气囊压力。观察到的损伤主要是尺骨或半径的横向,倾斜和楔形骨折,或两者,类似于现场调查中报告的那些。还发现了肘关节胶囊的泪水,两者都有和不骨折的前臂。关于气囊展开,远端前臂速度,气囊 - 模块到前臂间距,骨矿物质含量和上肢质量的时间分析了前臂断裂发生。如裂纹检测量输出所示,前臂骨折发生在5至10ms的安全气囊压力的发作内。发现骨折的时间与所得远端前臂加速度的局部减少,以及远端前臂速度的局部平台。峰值远端速度范围为9至21米/秒,当初始安全气囊模块到前臂间距从直接接触增加到2.5厘米时,当初始安全气囊模块到前臂间距增加,约30%。骨折和非断裂壳体之间的不同分裂是在约15.2米/升的峰值和11.7米/升的平均前臂速度下进行。由于初始气囊 - 模块 - 前臂间距增加,通常会降低远端前臂速度,断裂发射和断裂严重程度。另外,在直接接触条件下,骨折发生在矿物质含量小于1.03g / cm的骨骼中,但不在具有更大的矿物质内容物的骨骼中。发现远端前臂速度和矿物质含量与上肢的质量密切相关。因此,还发现前臂骨折的可能性与上肢的质量强烈相关。该研究的结果表明,气囊模块到前臂间距对司机诱导的气囊引起的上肢损伤具有大量影响。通过与安全气囊直接相互作用引起的前臂骨折的初始间隔增加了增加的初始间隔。此外,增加的初始间隔降低了远端前臂最终实现的速度,从而可能会减轻鞭毛损伤。结果还表明,用于预测前臂骨折的简单安全气囊仿真性评估工具可能基于生物偶像臂的峰值或平均远端前臂速度。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号