Studies and Application of Auger Monitoring System for Quality Control and Assurance of Al Bondpads

摘要

In wafer fabrication (Fab), Fluorine (F) based gases are used for Al bondpad opening process. Thus, even on a regular Al bondpad, there exists a low level of F contamination. However, the F level has to be controlled at a lower level. If the F level is higher than the control/spec limits, it could cause F-induced corrosion and Al-F defects, resulting in pad discoloration and NSOP problems. In our previous studies [15], the theories, characteristics, chemical and physical failure mechanisms and the root causes of the F-induced corrosion and Al-F defects on Al bondpads have been studied. In this paper, we further study F-induced corrosion and propose to establish an Auger monitoring system so as to monitor the F contamination level on Al bondpads in wafer fabrication. Auger monitoring frequency, sample preparation, wafer life, Auger analysis points, control/spec limits and OOC/OOS quality control procedures are also discussed.