Microtensile Bond Strength of Dual-cured Resin Luting Cements to Dentin by the type of Dentin Adhesives

摘要

This study was performed to investigate the bond strength between 4 dentin adhesives and resin luting cements by means of uTBS test. The materials used in this study were four resin cements (Choice, Panavia F, RelyX ARC, Bistite II DC), one 3-step adhesive (All-Bond2), one 2-step self-etching adhesive (Clearfil SE-Bond) and two 1-step self-etching adhesives(Prompt L-Pop and One-Up Bond F). Combination of 4 different dentin adhesives with 4 resin cements made up 16 experimental groups. Extracted human mandibular third molars without caries and restoratives were stored in saline and used within 1 month of extraction. All adhesive systems and resin cements were manipulated and applied to the dentin surfaces according to the manufactures' instructions. The resin composite "overlays" prepared with 6 mm thickness (Tescera, Bisco Inc., Schaumburg, IL, USA) were luted with each resin cement. Each sample was measured uTBS. 1-step self-etching adhesives coupled with all resin luting cements used in this study resulted in lower bond strength except of OU-PA group. When Choice, RelyX ARC and Bistite II were used, Clearfil SE-Bond showed significantly higher uTBS values than 1-step self-etching adhesives (p<0.05). Clearfil SE-Bond did not show significant μTBS values than All-Bond 2 that is conventional 3-step dentin adhesive (p>0.05).