首页> 外文会议>Smart Grid Conference >The estimation of inertia and load damping constants using phasor measurement data
【24h】

The estimation of inertia and load damping constants using phasor measurement data

机译:使用量相测量数据估计惯性和负载阻尼常数的估计

获取原文

摘要

Two very important parameters especially in frequency stability analysis, are inertia constant and equivalent load damping constant of system. Equivalent inertia constant depends on inertia constant of synchronous machines in the grid and load damping factor depends on frequency sensitivity of load, especially induction motors. By appearing wide area monitoring systems (WAMS) based on phasor measurement units, equivalent system frequency response can be obtained with high accuracy. In this paper firstly, the equivalent frequency response is achieved by phasor measurements and then according to the transient and steady state characteristics of the frequency response, the inertia and load damping constants are estimated. The performance of proposed method in estimating the equivalent parameters of the system is investigated under different conditions. The developed method is implemented in IEEE 39-Bus dynamic test grid.
机译:两个非常重要的参数,特别是在频率稳定性分析中,是惯性恒定和等效的负载阻尼恒定的系统。等效惯性恒定取决于网格中同步机的惯性常数,负载阻尼因子取决于负载的频率敏感性,尤其是感应电动机。通过基于Phasor测量单元出现广域监测系统(WAMS),可以高精度地获得等效的系统频率响应。在本文中,通过相位测量来实现等效频率响应,然后根据频率响应的瞬态和稳态特性,估计惯性和负载阻尼常数。在不同条件下研究了估计系统等同参数的所提出方法的性能。开发方法在IEEE 39总线动态测试网格中实现。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号