首页> 外文会议>Conference on physics of medical imaging >Analysis of Lung Nodule Detectability and Anatomical Clutter in Tomosynthesis Imaging of the Chest
【24h】

Analysis of Lung Nodule Detectability and Anatomical Clutter in Tomosynthesis Imaging of the Chest

机译:胸部断层合成成像中肺结节的可检测性和解剖杂波分析

获取原文

摘要

Tomosynthesis is an imaging technique that has gained renewed interest with recent advancements of flat-panel digital detectors. Because of the wide range of potential applications, a systematic analysis of 3D tomosynthesis imaging systems would contribute to the understanding and development. This paper extends a systematic evaluation of thoracic tomosynthetic imaging performance as a function of imaging parameters, such as the number of projections, tomosynthesis orbital extent, and reconstruction filters. We evaluate lung nodule detectability and anatomical clutter as a function of tomosynthesis orbital extent using anthropomorphic phantoms and a table-top acquisition system. Tomosynthesis coronal slices were reconstructed using the FDK algorithm for cone-beam geometry from 91 projections uniformly distributed over acquisition orbital extents (θ) ranging from 10° to 180°. Visual comparisons of different tomosynthesis reconstructions of a lung nodule show the progressive decrease of anatomical clutter as θ increases. Additionally, three quantitative figures of merit were computed and compared: signal-difference-to-noise ratio (SDNR), anatomical clutter power spectrum (PS), and theoretical detectability index (DI). Lung nodule SDNR increases as θ increases from 0° to 120°. Anatomical clutter PS shows that the clutter magnitude and correlation decrease as θ increases, increasing detectability. Similarly, 2D and 3D DI increase as 8 increases in the anatomical dominated exposure ranges. On the other hand, 2D slice DI is lower than the 3D DI for larger θ (e.g. 120°), because of the information loss in the depth direction for 2D slices. In other words, inspecting 3D is better for larger acquisition orbital extents, because the extra information acquired at larger angles cannot be fully recovered from 2D tomosynthesis reconstruction slices. In summary, detectability in tomosynthesis reconstructions for thoracic imaging increases as fixed dose is distributed over a larger acquisition orbital extent (up to 120°).
机译:Tomosynthesis是一种成像技术,它对平板数字探测器的最近进步获得了重新兴趣。由于各种潜在应用,3D自动合成成像系统的系统分析将有助于了解和发展。本文延伸了胸廓自愈性成像性能的系统评估,作为成像参数的函数,例如投影的数量,自来合的轨道范围和重建过滤器。我们使用拟蒽模和桌面采集系统评估肺结节可检测性和解剖杂波。使用91突起的锥形束几何形状重建了Tomosynthesis冠状切片,从91突起均匀分布在10°至180°的采集轨道范围内(θ)。肺结核的不同刺激性重建的视觉比较显示了作为θ增加的解剖学杂波的逐渐降低。另外,计算并比较了三个数量的优点图和:信号差 - 噪声比(SDNR),解剖杂波功率谱(PS)和理论可检测性指数(DI)。随着θ从0°增加到120°,肺结节SDNR增加。解剖杂波PS显示杂波幅度和相关性随着θ增加而降低,增加的可检测性。类似地,2D和3D Di增加到解剖标准曝光范围内的8增加。另一方面,由于2D切片的深度方向上的信息丢失,2D切片DI低于θ(例如120°)的3D DI。换句话说,对于较大的采集轨道范围,检查3D更好,因为在较大的角度获取的额外信息不能从2D断层合成重建切片完全恢复。总之,随着固定剂量的胸廓成像的可检测性随着固定剂量而增加,分布在较大的采集轨道范围(最多120°)上。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号