首页> 外文会议>AIAA/ASME/SAE/ASEE joint propulsion conference;AIAA propulsion and energy forum >Aerodynamic Effects of High Turbulence Intensity on a Variable-Speed Power-Turbine Blade with Large Incidence and Reynolds Number Variations
【24h】

Aerodynamic Effects of High Turbulence Intensity on a Variable-Speed Power-Turbine Blade with Large Incidence and Reynolds Number Variations

机译:高湍流强度对具有大入射角和雷诺数变化的变速动力涡轮叶片的空气动力学影响

获取原文

摘要

The effects of high inlet turbulence intensity on the aerodynamic performance of a variable speed power turbine blade are examined over large incidence and Reynolds number ranges. These results are compared to previous measurements made in a low turbulence environment. Both high and low turbulence studies were conducted in the NASA Glenn Research Center Transonic Turbine Blade Cascade Facility. The purpose of the low inlet turbulence study was to examine the transitional flow effects that are anticipated at cruise Reynolds numbers. The current study extends this to LPT-relevant turbulence levels while perhaps sacrificing transitional flow effects. Assessing the effects of turbulence at these large incidence and Reynolds number variations complements the existing database. Downstream total pressure and exit angle data were acquired for ten incidence angles ranging from +15.8° to -51.0°. For each incidence angle, data were obtained at five flow conditions with the exit Reynolds number ranging from 2.12×10~5 to 2.12×10~6 and at a design exit Mach number of 0.72. In order to achieve the lowest Reynolds number, the exit Mach number was reduced to 0.35 due to facility constraints. The inlet turbulence intensity, Tu, was measured using a single-wire hotwire located 0.415 axial-chord upstream of the blade row. The inlet turbulence levels ranged from 8% -15% for the current study. Tu measurements were also made farther upstream so that turbulence decay rates could be calculated as needed for computational inlet boundary conditions. Downstream flow field measurements were obtained using a pneumatic five-hole pitch/yaw probe located in a survey plane 7% axial chord aft of the blade trailing edge and covering three blade passages. Blade and endwall static pressures were acquired for each flow condition as well. The blade loading data show that the suction surface separation that was evident at many of the low Tu conditions has been eliminated. At the extreme positive and negative incidence angles, the data show substantial differences in the exit flow field. These differences are attributable to both the higher inlet Tu directly and to the thinner inlet endwall boundary layer that the turbulence grid imposes.
机译:在较大的入射角和雷诺数范围内,研究了高入口湍流强度对变速动力涡轮叶片的空气动力学性能的影响。将这些结果与以前在低湍流环境中进行的测量结果进行了比较。在美国国家航空航天局格伦研究中心跨音速涡轮叶片级联设施中进行了高湍流和低湍流研究。低入口湍流研究的目的是检查雷诺数巡航时预期的过渡流动效应。当前的研究将其扩展到与LPT有关的湍流水平,同时也许会牺牲过渡流动的影响。评估湍流对这些大事件和雷诺数变化的影响是对现有数据库的补充。获取了从+ 15.8°到-51.0°范围内的十个入射角的下游总压力和出口角数据。对于每个入射角,在五个流动条件下获得数据,出口雷诺数范围为2.12×10〜5到2.12×10〜6,设计出口马赫数为0.72。为了获得最低的雷诺数,由于设施限制,出口马赫数减​​少到0.35。入口湍流强度Tu是使用位于叶片行上游0.415轴向弦的单线热线测量的。对于当前研究,入口湍流水平范围为8%-15%。还对上游进行了Tu测量,以便可以根据计算入口边界条件的需要来计算湍流衰减率。下游流场测量是使用气动的五孔螺距/偏航探头获得的,该探头位于叶片后缘后轴向弦的7%的勘测平面中,并且覆盖三个叶片通道。还为每种流动条件获取了叶片和端壁的静压力。叶片载荷数据表明,在许多低Tu条件下明显的吸力表面分离已经消除。在极端的正入射角和负入射角下,数据显示出出口流场存在实质性差异。这些差异既可归因于较高的进气口Tu,又可归因于湍流栅格施加的较薄的进气口端壁边界层。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号