首页> 外文会议> >Dielectric and ferroelectric properties of 1-3 composites containing thin PZT-fibers
【24h】

Dielectric and ferroelectric properties of 1-3 composites containing thin PZT-fibers

机译:1-3种含细PZT纤维的复合材料的介电和铁电性能

获取原文

摘要

PbZr/sub 0.53/Ti/sub 0.47/O/sub 3/ (PZT)-fibers were prepared by a sol-gel route and appropriate thermal treatment. The sintered fibers show negligible porosity of about 100 nm in diameter and a narrow grain size distribution, the grain sizes ranging from 1 to 5 /spl mu/m depending on the sintering conditions. PZT-fiber/epoxy composites with 1-3 connectivity were prepared. Fiber volume fractions were adjusted from 20 to 70 vol.-%. Ferroelectric properties of composites with thicknesses between 0.05 and 0.5 mm are about 10 /spl mu/C/cm/sup 2/ for the remanent polarization and about 15 kV/mm for the coercive field. During longtime cycling of up to 10/sup 6/ cycles P/sub r/ nearly remains constant, E/sub c/ increases by 50%. A coupling coefficient k/sub t/ of up to 55% was measured. Perpendicular to the fiber direction a P/sub r/ of 0.8 /spl mu/C/cm/sup 2/ and an E/sub c/ of 2 kV/mm were measured.
机译:通过溶胶-凝胶法和适当的热处理制备PbZr / sub 0.53 / Ti / sub 0.47 / O / sub 3 /(PZT)-纤维。烧结纤维显示出可忽略的约100nm直径的孔隙率和窄的粒度分布,取决于烧结条件,粒度范围为1至5 /splμm/ m。制备了具有1-3个连通性的PZT-纤维/环氧树脂复合材料。纤维体积分数从20体积%调整至70体积%。厚度在0.05到0.5 mm之间的复合材料的铁电特性,对于剩余极化,约为10 / spl mu / C / cm / sup 2 /,对于矫顽场,约为15 kV / mm。在长达10 / sup 6 /个周期的长时间循环中,P / sub r /几乎保持不变,E / sub c /增加了50%。测得的耦合系数k / sub t /高达55%。垂直于纤维方向测得的P / sub r /为0.8 / spl mu / C / cm / sup 2 /和E / sub c /为2 kV / mm。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号