Influence of Concentration and Additives on R123/Paraffinic Material Oil Boiling Heat Transfer Performance

摘要

This report investigates the effect that oil concentration had on the boiling performance of an R123/paraffinic mineral oil mixture on a roughened, horizontal flat surface. For all compositions (0.5 %, 1%, and 2%), the lubricant caused a heat transfer degradation relative to the heat transfer of pure R123 of between 2% and 70% for the range of measured heat fluxes. The heat transfer degradation was shown to increase with lubricant mass fraction. The minimum heat transfer degradation for each mixture ranged between 2% and 12% and occurred at approximately 20 kW/m2. For a given composition, the heat transfer degradation increased as the heat flux increased from roughly 20 kW/m2 to 90 kW/m2. In addition, the effect of two trial additives on the pool boiling heat transfer of an R123/paraffinic mineral oil mixture was examined in order to test the validity of a theory for choosing oil additives to enhance boiling performance. The verification tests were inconclusive. More research with lubricants and additives with greater differences in surface tensions is required to develop a more rigorous and quantifiable theory for designing additives that improve boiling heat transfer.