Equations were derived representing heat transfer and pressure drop for a gas flowing in the passages of a heater composed of a series of parallel flat plates. The plates generated heat which was transferred to the flowing gas by convection. The relatively high temperature level of this system necessitated the consideration of heat transfer between the plates by radiation.nThe equations were solved on an IBM 704 computer, and results were obtained for hydrogen as the working fluid for a series of cases with a gas inlet temperature of 200° R, an exit temperature of 5000° R, and exit Mach numbers ranging from 0.2 to 0.8. The length of the heater composed of the plates ranged from 2 to 4 feet, and the spacing between the plates was varied from 0.003 to 0.01 foot. Most of the results were for a five-plate heater, but results are. also given for nine plates to show the effect of increasing the number of plates. The heat generation was as¬sumed to be identical for each plate but was varied along the length of the plates. The axial variation of power used to obtain the results pre¬sented is the so-called "2/3-coslne variation." The boundaries surround¬ing the set of plates, and parallel to it, were assumed adiabatic, so that all the power generated in the plates went into heating the gas.nThe results are presented in plots of maximum plate and maximum adi¬abatic wall temperatures as functions of parameters proportional to f(L/D), for the case of both laminar and turbulent flow. Here f is the Fanning friction factor and (L/D) is the length to equivalent diameter ratio of the passages in the heater. The pressure drop through the heat¬er is presented as a function of these same parameters, the exit Mach number, and the pressure at the exit of the heater.
展开▼
