首页> 外文期刊>Philosophical Magazine, A. Physics of condensed matter, defects and mechanical properties >Influence of precipitates on the microstructure and texture during the rolling of Al-Cu and Al-Mn single crystals with rolling texture orientations
【24h】

Influence of precipitates on the microstructure and texture during the rolling of Al-Cu and Al-Mn single crystals with rolling texture orientations

机译:析出物对轧制织构取向的Al-Cu和Al-Mn单晶轧制过程中显微组织和织构的影响

获取原文
获取原文并翻译 | 示例
       

摘要

The influence of precipitates on the development of microstructure and crystallographic texture during cold rolling was investigated in particle-containing Al-Cu and Al-Mn single crystals with the initial orientations (011)[100], (011)[21 (1) over bar] and (112)[11 (1) over bar]. Analysis of the X-ray rolling textures yielded broad scatter of the initial orientations around axes close to the transverse direction. By means of microstructural investigations and local orientation measurements in the transmission electron microscope this scatter could be attributed to the disturbed volumes around the particles, the so-called deformation zones. The evolution of the deformation zones as well as their impact on the rolling texture is discussed. In particular, the orientation correlation between deformation zones and matrix is analysed and the influence of different particle morphologies is addressed. [References: 35]
机译:在初始取向为(011)[100],(011)[21(1)]的含颗粒Al-Cu和Al-Mn单晶中研究了析出物对冷轧过程中显微组织和晶体织构发展的影响。 bar]和(112)[11(1)over bar]。对X射线滚动纹理的分析产生了围绕垂直于横向方向的轴的初始方向的广泛散布。通过透射电子显微镜中的微观结构研究和局部取向测量,可以将这种散射归因于颗粒周围的受干扰体积,即所谓的变形区。讨论了变形区的演变及其对轧制织构的影响。特别是,分析了变形区和基体之间的方向相关性,并研究了不同颗粒形态的影响。 [参考:35]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号