...
首页> 外文期刊>Physics in medicine and biology. >Scan equalization digital radiography (SEDR) implemented with an amorphous selenium flat-panel detector: initial experience.
【24h】

Scan equalization digital radiography (SEDR) implemented with an amorphous selenium flat-panel detector: initial experience.

机译:使用非晶硒平板探测器实现的扫描均衡数字射线照相(SEDR):初步经验。

获取原文
获取原文并翻译 | 示例
           

摘要

It is well recognized in projection radiography that low-contrast detectability suffers in heavily attenuating regions due to excessively low x-ray fluence to the image receptor and higher noise levels. Exposure equalization can improve image quality by increasing the x-ray exposure to heavily attenuating regions, resulting in a more uniform distribution of exposure to the detector. Image quality is also expected to be improved by using the slot-scan geometry to reject scattered radiation effectively without degrading primary x-rays. This paper describes the design of a prototype scan equalization digital radiography (SEDR) system implemented with an amorphous silicon (a-Si) thin-film transistor (TFT) array-based flat-panel detector. With this system, slot-scan geometry with alternate line erasure and readout (ALER) technique was used to achieve scatter rejection. A seven-segment beam height modulator assembly was mounted onto the fore collimator to regulate exposure regionally for chest radiography. The beam modulator assembly, consisting of micro linear motors, lead screw cartridge with lead (Pb) beam blockers attached, position feedback sensors and motor driver circuitry, has been tested and found to have an acceptable response for exposure equalization in chest radiography. An anthropomorphic chest phantom was imaged in the posterior-anterior (PA) view under clinical conditions. Scatter component, primary x-rays, scatter-to-primary ratios (SPRs) and primary signal-to-noise ratios (PSNRs) were measured in the SEDR images to evaluate the rejection and redistribution of scattered radiation, and compared with those for conventional full-field imaging with and without anti-scatter grid methods. SPR reduction ratios (SPRRRs, defined as the differences between the non-grid full-field SPRs and the reduced SPRs divided by the former) yielded approximately 59% for the full-field imaging with grid and 82% for the SEDR technique in the lungs, and 77% for the full-field imaging with grid and 95% for the SEDR technique in the subdiaphragm. The SEDR technique demonstrated a substantial improvement in PSNRs over the anti-scatter grid technique. The improvements of PSNRs varied with the regions and are more pronounced in heavily attenuating regions.
机译:在投影射线照相术中,众所周知,由于对图像受体的过低X射线通量和较高的噪声水平,在较大的衰减区域中会出现低对比度的可检测性。曝光均衡可以通过增加对严重衰减区域的X射线曝光来提高图像质量,从而使检测器的曝光分布更加均匀。还期望通过使用缝隙扫描几何结构有效地拒绝散射辐射而不会降低初级X射线,从而提高图像质量。本文介绍了基于基于非晶硅(a-Si)薄膜晶体管(TFT)阵列的平板探测器实现的原型扫描均衡数字射线照相(SEDR)系统的设计。在该系统中,采用了具有交替行擦除和读出(ALER)技术的缝隙扫描几何结构来实现散射抑制。七段光束高度调制器组件安装在前准直仪上,以局部调节胸部X射线照相的曝光量。经过测试的光束调制器组件由微型线性电机,附有铅(Pb)光束阻挡器的导螺杆盒,位置反馈传感器和电机驱动器电路组成,已经过测试,对于胸部X线摄影中的曝光均衡具有可接受的响应。在临床条件下,在后-前(PA)视图中拍摄了拟人化的人体模型。在SEDR图像中测量了散射成分,主要x射线,主要散射比(SPR)和主要信噪比(PSNR),以评估散射辐射的抑制和重新分布,并与常规方法进行比较具有和不具有防散射网格方法的全场成像。 SPR降低率(SPRRR,定义为非网格全场SPR与减少后的SPR之间的差除以前者)对于使用网格的全场成像大约占59%,对于SEDR技术在肺部成像时占82% ,而在横dia膜下使用网格进行全场成像的比例为77%,对于SEDR技术则为95%。 SEDR技术比抗散射网格技术显示出PSNR的显着改善。 PSNR的改善随区域而异,在严重衰减的区域中更为明显。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号